Behavior of Sand-Reinforced with Waste Tire Shreds Using CBR Tests

سال انتشار: 1380
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 3,644

فایل این مقاله در 10 صفحه با فرمت PDF قابل دریافت می باشد

استخراج به نرم افزارهای پژوهشی:

لینک ثابت به این مقاله:

شناسه ملی سند علمی:

GIC01_05

تاریخ نمایه سازی: 12 آذر 1384

چکیده مقاله:

The Reinforcement of soil and environmental considerations have led to the use of waste tires. In this paper the influence of tire shred contents, compaction energy, and the dimensions of rectangular shreds on California Bearing Ratio (CBR) of sand-tire shred mixtures is investigated. Tire shreds with rectangular shape and widths of 2, 3, and 4 cm were mixed with sand. Three shred contents of 15%, 30%, and 50% by volume were chosen and mixed with the sand to obtain uniform mixtures. In order to compare the compression strength of different sand-tire shred samples in CBR tests, two compaction efforts in terms of sand matrix unit weights of 15,5 kN/m3 and 16,8 kN/m3 were considered. The results show that the influencing parameters on CBR of the mixtures are sand matrix unit weight, shred content, shred width, and aspect ratios of tire shreds. For a given width of shreds, compaction effort, and shred content, the variation of aspect ratios can increase CBR up to 850%. The average value for the influence of aspect ratio variations on CBR of the mixtures for all tests has been found to be about 161%. These average values for lower and higher compacted samples containing different widths and aspect rations were 284% and 38%, respectively. It has been investigated that for a given width of tire rectangular shreds, there is only a particular length, which gives the greatest value for CBR of sand-tire shred mixtures. This is the main objective sought in this paper.

نویسندگان

Mahmoud Ghazavi

Assistant Professor, Civil Engineering Department, Isfahan University of Technology

Masoud Masoud

Graduate Student, Civil Engineering Department, Isfahan University of Technology

مراجع و منابع این مقاله:

لیست زیر مراجع و منابع استفاده شده در این مقاله را نمایش می دهد. این مراجع به صورت کاملا ماشینی و بر اساس هوش مصنوعی استخراج شده اند و لذا ممکن است دارای اشکالاتی باشند که به مرور زمان دقت استخراج این محتوا افزایش می یابد. مراجعی که مقالات مربوط به آنها در سیویلیکا نمایه شده و پیدا شده اند، به خود مقاله لینک شده اند :
  • Ahmed, I., and Lovell, C. (1993).، 'Use of rubber tires ...
  • Allman, M. A., and Simundic, G. (1998). *Testing of a ...
  • Bosscher, J., Edill, T. B., and Kuraoke, S. (1997). *Desing ...
  • Edil, T. B., and Bosscher, P. J. (1994). *Engineering Properties ...
  • Eldin, N. N., and Senouci, A. B. (1993).، Rubber-Tire Particles ...
  • Foose, J., Benson, H., and Bosscher, J. (1996). _ Reinforced ...
  • Garga, V. K., and O' Shaughnessy, V. (2000a).، ،T i ...
  • Garga, V. K., and O 'Shaughnessy, V. (2000b).، ، T ...
  • Garga, V. K., and O 'Shaughnessy, V. (2000c).، ،T i ...
  • Ghazavi, M. and Amel-Sakhi, M. (2002).، ،Shear Strength Parameters of ...
  • Hall, T. (1991).، Reuse of Shredded Tire Material for Leachate ...
  • Heimdahl, C., and Druscher, A. (1999).، Elastic Anisotropy of Tire ...
  • Humphrey, D.N., and Manion, W.P. (1992). *Properties of tire chips ...
  • Humphrey, D. N., and Nickels, W. L. (1997). «Effect of ...
  • Humphrey, D. N., Katz, L. E., and Blumenthal, M. (1997).، ...
  • Lee, J. H., Salgado, R., Bernal, A., and Lovell, C. ...
  • Nightingale, D. E. B., and Green, W. P. (1997).، 0An ...
  • O' Rourke, T. D., Druschel, S. J., and Netravali, A. ...
  • Poh, P. S. H., and Broms, B. B., _ Stabilization ...
  • S umanarathna, I. H. D., _ allawarctchie, D. P., and ...
  • Tuncan, M, Cetin, A., Tuncan, A., and Koyuncu, _ (1998).، ...
  • Tweedie J.J, Humphrey, D.N., and Sanford, T.C. (1998).، .Tire-Shreds as ...
  • Wu, W. Y., Benda, C. C., and Cauley, R. F. ...
  • نمایش کامل مراجع