Pervaporation study of ceramic-supported thin PVA membranes in dehydration of ethanol: Effect of PVA coating gel concentration

سال انتشار: 1390
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 490

فایل این مقاله در 8 صفحه با فرمت PDF قابل دریافت می باشد

استخراج به نرم افزارهای پژوهشی:

لینک ثابت به این مقاله:

شناسه ملی سند علمی:

ICHEC07_178

تاریخ نمایه سازی: 25 فروردین 1394

چکیده مقاله:

Thin polyvinyl alcohol (PVA) layers were prepared on top of porous molite ceramic supports.Mercury porosimetry analysis was carried out confirming a porosity of 22%-34% for the supports respect to the sintering condition. Ceramic-supported thin PVA membranes were characterized viaSEM and dehydration of aqueous ethanol. Thickness of the PVA layer formed on top of the support was in the range of 2–10 μm. Effects of PVA concentration in the coating gel on thickness and density of the active layers were investigated using SEM micrographs. PVA concentration ofthe coating gel is the most effective parameter on active layers thickness and density, after repetition of the coating process. Dehydration of ethanol was performed at 30–60 °C with feed water concentration of 10 wt.%. These membranes exhibited adequate water fluxes (14–81 g/m2h)and high separation factors (44–119). The flux and separation factor values exceeded typicalvalues obtained for PVA membranes. The novel ceramic support increases mechanical strength ofthe membrane and protects the ultrathin polymer top layer under aggressive operating conditions, specially the pressure gradient across the membrane, resulting in high flux. Besides decreasing swelling of the PVA top layer, results in high separation factor. These two are both favorable foran effective separation but in common polymeric membranes increasing one of them diminishes the other one. However this novel ultrathin PVA membrane has the advantages of high selectivity beside high permeation flux

نویسندگان

Mohammad Samei

Research Centre for Membrane Separation Processes, Chemical Engineering Department Iran University of Science and Technology (IUST), Narmak, Tehran, Iran

Amir Atabak Asadi

Research Centre for Membrane Separation Processes, Chemical Engineering Department Iran University of Science and Technology (IUST), Narmak, Tehran, Iran

Toraj Mohammadi

Research Centre for Membrane Separation Processes, Chemical Engineering Department Iran University of Science and Technology (IUST), Narmak, Tehran, Iran

مراجع و منابع این مقاله:

لیست زیر مراجع و منابع استفاده شده در این مقاله را نمایش می دهد. این مراجع به صورت کاملا ماشینی و بر اساس هوش مصنوعی استخراج شده اند و لذا ممکن است دارای اشکالاتی باشند که به مرور زمان دقت استخراج این محتوا افزایش می یابد. مراجعی که مقالات مربوط به آنها در سیویلیکا نمایه شده و پیدا شده اند، به خود مقاله لینک شده اند :
  • Q.G. Zhang, Q.L. Liu, Y. Chen, J.H. Chen, Dehydration of ...
  • X. Feng, R.Y.M. Huang, Liquid Separation by Membrane Pervaporation: A ...
  • S. Razavi, A. Sabetghadam, T. Mohammadi, Dehydration of isopropanol by ...
  • T.A. Peters, C.H.S. Poeth, N.E. Benes, H.C.W.M. Buijs, F.F. Vercauteren, ...
  • _ Internationt Chemical Engineering Congress & Exhibition Kish, Iran, 21-24 ...
  • high selectivity; contradicting the flux-selectivity paradigm, Journal of Membrane Science, ...
  • W. Yoshida, Y. Cohen, Ceramic- supported polymer membranes for pervaporation ...
  • S.J. Lue, D.-T. Lee, J.-Y. Chen, C.-H. Chiu, C.-C. Hu, ...
  • نمایش کامل مراجع