Experimental Study of Wire Electrical Discharge Machining of INCONEL 738LC
سال انتشار: 1386
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 1,988
فایل این مقاله در 7 صفحه با فرمت PDF قابل دریافت می باشد
- صدور گواهی نمایه سازی
- من نویسنده این مقاله هستم
استخراج به نرم افزارهای پژوهشی:
شناسه ملی سند علمی:
ICME08_091
تاریخ نمایه سازی: 27 آبان 1388
چکیده مقاله:
The experimental study presented in this paper aims to study the effects of WEDM (Wire Electrical Discharge Machining) cutting parameters on surface roughness. The experiments have been performed on an Inconel 738LC specimen cut from root of a turbine blade of thickness of 23mm. The experiments carried out on a wire electrical discharge machine where eight parameters have been changed based on Taguchi table. The surface roughness of the testpieces has been measured with a digital surface measuring device. The analysis of the results shows the effect of each parameter on the surface roughness.
کلیدواژه ها:
نویسندگان
K.T Maralani
MSc. student of Urmia University
J Akbari
Associate Professor, School of Mechanical Engineering, Sharif University of Technology
M Sabet
Associate professor, Department of Engineering, Urmia University
مراجع و منابع این مقاله:
لیست زیر مراجع و منابع استفاده شده در این مقاله را نمایش می دهد. این مراجع به صورت کاملا ماشینی و بر اساس هوش مصنوعی استخراج شده اند و لذا ممکن است دارای اشکالاتی باشند که به مرور زمان دقت استخراج این محتوا افزایش می یابد. مراجعی که مقالات مربوط به آنها در سیویلیکا نمایه شده و پیدا شده اند، به خود مقاله لینک شده اند :