Visualization of Fiber Orientation in Weldlines of a RTM Part With Different Injection Spots
محل انتشار: دهمین کنفرانس ملی مهندسی ساخت و تولید
سال انتشار: 1388
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 1,831
فایل این مقاله در 6 صفحه با فرمت PDF قابل دریافت می باشد
- صدور گواهی نمایه سازی
- من نویسنده این مقاله هستم
استخراج به نرم افزارهای پژوهشی:
شناسه ملی سند علمی:
ICME10_030
تاریخ نمایه سازی: 29 آبان 1388
چکیده مقاله:
Resin transfer molding (RTM) is a widely used manufacturing technique for composite parts. The focus of attention is kept on weldline behavior in parts of complex geometry, i.e. the composite engine cover which is placed on top of cylinder head in TOYOTA car (Camry 2007). By simulating the filling process using simulation software Moldflow, the fiber orientation behavior was investigated in weldline zones and the best injection spot for filling process of this part, by comparing the weldline zones, determined. Hence, best injection spot could help reduce the weldline area and a distinct information about fiber orientation manner in weldline zones placed in high sensetive areas of finished part could help researchers and product development engineers dealing with composites to minimize zones with weak mechanical points in plastic parts.
کلیدواژه ها:
RTM – Simulation – Fiber orientation – Weldline
نویسندگان
Hadi Sedaghat Pishe
MSc. Student, Faculty of Mechanical Engineering, University of shahre-kord
Hossein Golestanian
Assistant Professor, Faculty of Mechanical Engineering, University of Shahre-kord
Taher Azdast
Assistant Professor, Faculty of Engineering,Mechanical Engineering Department, Urmia University