Experimental study on out of roundness of flow-formed AISI 321 steel tube by design of experiment
محل انتشار: یازدهمین کنفرانس ملی مهندسی ساخت و تولید ایران
سال انتشار: 1389
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 2,260
فایل این مقاله در 10 صفحه با فرمت PDF قابل دریافت می باشد
- صدور گواهی نمایه سازی
- من نویسنده این مقاله هستم
استخراج به نرم افزارهای پژوهشی:
شناسه ملی سند علمی:
ICME11_002
تاریخ نمایه سازی: 3 مرداد 1389
چکیده مقاله:
Flow forming of cylindrical tubes is an effective process for manufacturing thin-walled seamless tubes. In this study the out of roundness (OOR) of a flow-formed AISI 321 steel tubing pre-form was investigated for various levels of process parameters experimentally. Taguchi method was employed to plan of experiments. The parameters considered are the feed rate (mm/min), the depth of cut (mm) and the roller attack angle. The effects and contributions of these parameters on the out of roundness as response have been analyzed. It has been found that the depth of cut is the most important process parameter affecting out of roundness. The out of roundness was found to increase with increase in the depth of cut and roller attack angle.
کلیدواژه ها:
flow forming – Taguchi method – AISI 321 steel – out of roundness
نویسندگان
N. Razani
MSc. Student, Department of Engineering and High Tech, Iran University of Industries and Mines
B. Mollaei Dariani
Associate Professor, Mchanical Department, Amirkabir University
A. Jalali Aghchai
Assistant Professor, Department of Engineering and High Tech, Iran University of Industries and Mines
مراجع و منابع این مقاله:
لیست زیر مراجع و منابع استفاده شده در این مقاله را نمایش می دهد. این مراجع به صورت کاملا ماشینی و بر اساس هوش مصنوعی استخراج شده اند و لذا ممکن است دارای اشکالاتی باشند که به مرور زمان دقت استخراج این محتوا افزایش می یابد. مراجعی که مقالات مربوط به آنها در سیویلیکا نمایه شده و پیدا شده اند، به خود مقاله لینک شده اند :