Solution-based molybdenum oxide as a good hole injection layer in organic light emitting diode
سال انتشار: 1393
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 393
متن کامل این مقاله منتشر نشده است و فقط به صورت چکیده یا چکیده مبسوط در پایگاه موجود می باشد.
توضیح: معمولا کلیه مقالاتی که کمتر از ۵ صفحه باشند در پایگاه سیویلیکا اصل مقاله (فول تکست) محسوب نمی شوند و فقط کاربران عضو بدون کسر اعتبار می توانند فایل آنها را دریافت نمایند.
- صدور گواهی نمایه سازی
- من نویسنده این مقاله هستم
استخراج به نرم افزارهای پژوهشی:
شناسه ملی سند علمی:
ICNN05_787
تاریخ نمایه سازی: 30 آبان 1394
چکیده مقاله:
Molybdenum oxide thin film prepared from a aqueous solution as a good hole injection layer (HIL) inorganic light emitting diode. Molybdenum Oxide can be well substituted to Poly(3,4-ethylenedioxythiophene):polystyrene sulfonate (PEDOT:PSS) which is a conventional HIL. In this report variousconditions of thin film fabrication were done such as; thickness, annealing temperature, annealing atmosphere, and UV Ozone treatment. The performance of organic light emitting diode (OLED) fabricated using molybdenum oxide showed a good results against one fabricated using PEDOT:PSS. Chemical and electronic structure of the layer was indicated by X-ray/ultraviolet photoelectron spectroscopy (XPS/UPS).
کلیدواژه ها:
نویسندگان
H Alehdaghi
Department of Physics, Sharif University of Technology, Tehran, Iran- Advanced Display Research Center, Kyung Hee University, Seoul, korea
M Marandi
Department of Physics, Faculty of Sciences, Arak University, Arak, Iran
A Irajizad
Department of Physics, Sharif University of Technology, Tehran, Iran
N Taghavinia
Department of Physics, Sharif University of Technology, Tehran, Iran