Response surface modeling and optimization of equivalent plastic strain in equal channel angular rolling

سال انتشار: 1393
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 1,116

فایل این مقاله در 6 صفحه با فرمت PDF قابل دریافت می باشد

استخراج به نرم افزارهای پژوهشی:

لینک ثابت به این مقاله:

شناسه ملی سند علمی:

IIAC03_041

تاریخ نمایه سازی: 9 فروردین 1395

چکیده مقاله:

Equal channel angular rolling (ECAR) process is a severe plastic deformation technique which is performed on metallic sheets and strips. It helps to obtain the desired mechanical and physical properties through refining the grain size. In this paper, the effect of the ECAR process parameters, the thickness ratio ( k ), the die channel angle (F ), the die outer corner angle ( Y ), the fillet radius (r), the friction coefficient between strip and rolls ( μ ) and the friction factorbetween strip and die ( m) on the equivalent plastic strain (PEEQ) have been investigated. A simple and efficientquadratic model has been obtained to predict the PEEQ as the function of the ECAR parameters. The results showed that the die channel angle is the most significant parameter while the friction coefficient between the strip and the rolls has no considerable effect on the PEEQ. Furthermore, it is found that there are some interactions between the ECAR process parameters. The optimum values of the parameters which result in the maximum PEEQ, k = 0.96, F = 90.10 , Y = 21.21 , r = 2.31mm, μ = 0.20 and m = 0.19 , have been determined using finite element analysis and response surface methodology with central composite design. An improvement about 14.86% in the PEEQ was achieved by setting the optimum values for the process parameters.

کلیدواژه ها:

نویسندگان

r Nemati Chari

Department of Mechanical Engineering, Amirkabir University of Technology, Tehran, Iran

a kami

Department of Mechanical Engineering, Amirkabir University of Technology, Tehran, Iran

b Mollaei Dariani

Department of Mechanical Engineering, Amirkabir University of Technology, Tehran, Iran

مراجع و منابع این مقاله:

لیست زیر مراجع و منابع استفاده شده در این مقاله را نمایش می دهد. این مراجع به صورت کاملا ماشینی و بر اساس هوش مصنوعی استخراج شده اند و لذا ممکن است دارای اشکالاتی باشند که به مرور زمان دقت استخراج این محتوا افزایش می یابد. مراجعی که مقالات مربوط به آنها در سیویلیکا نمایه شده و پیدا شده اند، به خود مقاله لینک شده اند :
  • Numerical modeling 4ه Narayanasamy, C. AhamedBasha, of aluminum sheets formability ...
  • Procedings of Iran International Aluninu Conference (IIAC2ot4) _ Mag 25-26, ...
  • by equal channel angular rolling, Journal of Materials Processing Technology. ...
  • "Controlling the texures of the metal strips via the continuous ...
  • Tagore, _ Analysis of Sheet Metal Formability Studies of Friction ...
  • surface methodology for design of sheet forming parameters to control ...
  • R.N. Ramanan, A. Azlan, A. Ismail, _ Response surface optimisation ...
  • User's guide, Minneapolis, 2005. M.J. Anderson, ...
  • نمایش کامل مراجع