A New Method for Automation and Optimization of Pot lines in Aluminum Factories

سال انتشار: 1397
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 459

نسخه کامل این مقاله ارائه نشده است و در دسترس نمی باشد

استخراج به نرم افزارهای پژوهشی:

لینک ثابت به این مقاله:

شناسه ملی سند علمی:

IIAC05_045

تاریخ نمایه سازی: 27 تیر 1398

چکیده مقاله:

In this paper, the potline section of Iranian Aluminium Company is taken into consideration .From technical, manpower, and economic viewpoint, the voltage fluctuation is considered as one of the main problems in this section. This problem is mostly made as the result of the sludge created at the pot bottom, the drying of the crust surface, the anode effect, and so on.In the old and new lines, these fluctuations are chiefly controlled by non-optimal methods using a lot of manpower in which the voltage fluctuations can create a lot of risks and costs for both the factory and the power network.In this study, due to the consecutive property of the reduction cells, we designed a mechanism that had the ability to pass high current through the pot lines in such a way that it could control the pots in a parallel independent series from each other; and could stabilize all the cells during any fluctuation and after that. In this method, the speed of retaining the normal mode after fluctuation increased and the manpower was used more logically and with more accuracy. Also, a significant improvement was noticed in the consumption of energy, costs, and rate of production as well as a considerable improvement in safety.

کلیدواژه ها:

نویسندگان

Bahman Eskandari

Department of Power electrical Engineering, Malayer University, Malayer, Iran

Salman Shokri

Iranian Aluminium company, IRALCO, Arak, P.O. Box: ۳۸۱۸۹-۹-۸۱۱۶, Iran

Mostafa Khodarahmi

Departrnent of Power electrical Engineering, Energy Management, Shahab Danesh University, Qom, Iran