Finite Element Modeling of Deep Drawing Process

سال انتشار: 1385
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 2,300

فایل این مقاله در 7 صفحه با فرمت PDF قابل دریافت می باشد

استخراج به نرم افزارهای پژوهشی:

لینک ثابت به این مقاله:

شناسه ملی سند علمی:

ISME14_489

تاریخ نمایه سازی: 1 فروردین 1386

چکیده مقاله:

In the present investigation, a deep-drawing process is simulated using the finite element method. Both the elastoplastic and the elastoviscoplastic behavior of the deformable blank are studied and the results are compared to show the effect of loading rate on the forming of metal. Because of the low anisotropy of the sheet metal, the material is assumed to be isotropic and Von-Mises yield criterion is employed. The effect of different process parameters such as friction coefficient and punch velocity, are investigated, and several conclusive results are presented.

کلیدواژه ها:

Deep-Drawing Process - Finite Element Simulation - Plastic Deformation - Viscoplastic Deformation

نویسندگان

Shahani

Associate Professor, Faculty of Mechanical Engineering, K.N.T University of Technology

Salehinia

Graduate Students, Faculty of Mechanical Engineering, K.N.T University of Technology

Nodamaie

Graduate Students, Faculty of Mechanical Engineering, K.N.T University of Technology

Shiehbeiki

IRAN Khodro Co. Engineers, IranKhodro Co., Tehran, Iran

مراجع و منابع این مقاله:

لیست زیر مراجع و منابع استفاده شده در این مقاله را نمایش می دهد. این مراجع به صورت کاملا ماشینی و بر اساس هوش مصنوعی استخراج شده اند و لذا ممکن است دارای اشکالاتی باشند که به مرور زمان دقت استخراج این محتوا افزایش می یابد. مراجعی که مقالات مربوط به آنها در سیویلیکا نمایه شده و پیدا شده اند، به خود مقاله لینک شده اند :
  • Woo, D.M, "The stretching forming test" The Engineer, vol.20), 1965, ...
  • Wang, N.M., Budiansky, B., "Analysis of sheet metal stamping by ...
  • Tang, S. C., "Large elasto-plastic strain analysis of Flange hole ...
  • S. Kobayashi, S. I. Oh, Altan, T., Metal Forming and ...
  • Hsu, T.C, and Chu, C.H., "A finite -element analysis of ...
  • Wifi, A. S., "An incremental complete solution of the S ...
  • Forming 20X0, Pietrzyk et all. (eds) 2000 Balkema, Rotterdam, pp. ...
  • Chenot, J.- L., and Massoni, E., "On membrane and shel] ...
  • Takuda, H., Enami, T., Kubota, K., and Hatta, N., "The ...
  • L. Duchene, ،FEM Study of Metal Sheets with a Texture ...
  • J. Horsky, *Optimization of Forging Characteristic S of Metal in ...
  • نمایش کامل مراجع