enhancing efficiency of softwarw fault tolerance techniques in satellite motion system

سال انتشار: 1393
نوع سند: مقاله ژورنالی
زبان: انگلیسی
مشاهده: 698

فایل این مقاله در 8 صفحه با فرمت PDF قابل دریافت می باشد

استخراج به نرم افزارهای پژوهشی:

لینک ثابت به این مقاله:

شناسه ملی سند علمی:

JR_JIST-2-7_006

تاریخ نمایه سازی: 12 آبان 1393

چکیده مقاله:

This research shows the influence of using multi-core architecture to reduce the execution time and thus increase performance of some software fault tolerance techniques. According to superiority of N-version Programming and Consensus Recovery Block techniques in comparison with other software fault tolerance techniques, implementations were performed based on these two methods. Finally, the comparison between the two methods listed above showed that the Consensus Recovery Block is more reliable. Therefore, in order to improve the performance of this technique, we propose a technique named Improved Consensus Recovery Block technique. In this research, satellite motion system which known as a scientific computing system is consider as a base for our experiments. Because of existing any error in calculation of system may result in defeat in system totally, it shouldn’t contains any error. Also the execution time of system must be acceptable. In our proposed technique, not only performance is higher than the performance of consensus recovery block technique, but also the reliability of our proposed technique is equal to the reliability of consensus recovery block technique. The improvement of performance is based on multi-core architecture where each version of software key units is executed by one core. As a result, by parallel execution of versions, execution time is reduced and performance is improve

نویسندگان

Hoda Banki

Department of Electrical and Computer Engineering, University of Kashan, Isfahan, Iran

Seyed Morteza Babamir

Department of Electrical and Computer Engineering, University of Kashan, Isfahan, Iran

Azam Farokh

Department of Electrical and Computer Engineering, University of Kashan, Isfahan, Iran

Mohammad Morovati

Department of Electrical and Computer Engineering, University of Kashan, Isfahan, Iran