HEAT TRANSFER IN COMMERCIAL IMPINGEMENT OVENS

سال انتشار: 1390
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 1,627

فایل این مقاله در 6 صفحه با فرمت PDF قابل دریافت می باشد

استخراج به نرم افزارهای پژوهشی:

لینک ثابت به این مقاله:

شناسه ملی سند علمی:

MEDC01_049

تاریخ نمایه سازی: 11 شهریور 1391

چکیده مقاله:

A point of concern when using air impingement ovens is the wide variation of heat transfer coefficient on the surface of a product. Practically two sources of non-uniformity exist: local variation of heat transfer coefficient of jets and non-uniform air velocity of finger duct nozzles. Local variation of heat transfer coefficient was investigated by numerical simulation using v2 f turbulence model and non-uniform air velocity of nozzles was investigated by numerical simulation of air flowing through tapered duct. Results showed that Jet temperature variation did not affect the Nu distribution. The Numax was more than twice of Nuave. Also, for the desired jet velocity (10 m/s), the average jet velocity of nozzles increased along with finger duct of Oven from 8.8 m/s to its maximum value (13.9 m/s). The difference between maximum and minimum jet velocities was 58%. The horizontal components of velocity increased along with duct that result in higher flow divergence from nozzles exit and consequently lower heat transfer on a product surface.

نویسندگان

Salem Banooni

Department of Mechanical Engineering, Engineering Faculty, Shahid Chamran University, Ahvaz, Iran,

Koroush Goudarzi

Department of Mechanical Engineering, Engineering Faculty, Yasooj University, Yasooj, Iran

Maysam Molana

Department of Mechanical Engineering, Engineering Faculty, Shahid Chamran University, Ahvaz, Iran,

مراجع و منابع این مقاله:

لیست زیر مراجع و منابع استفاده شده در این مقاله را نمایش می دهد. این مراجع به صورت کاملا ماشینی و بر اساس هوش مصنوعی استخراج شده اند و لذا ممکن است دارای اشکالاتی باشند که به مرور زمان دقت استخراج این محتوا افزایش می یابد. مراجعی که مقالات مربوط به آنها در سیویلیکا نمایه شده و پیدا شده اند، به خود مقاله لینک شده اند :
  • Wahlby U.; Skjoldebrand Ch.; Junker E. 2000, Impact of impingement ...
  • Li, A.; Walker, C.E. 1996, Cake baking in conventional impingement ...
  • Moriera R.G 2001, Impingement drying of food using hot air ...
  • Thielen, T.; Jonker, J. 2001, Numerical study of the flow ...
  • Baughn J.W.; Shimizu S. 1989, Heat transfer meas urements from ...
  • Wang S.J.; Mujumdar A.S., 2005, A comparative study of five ...
  • Hos seinalipour, S.M.; Mujumdar, A.S., 1995, Comparative evaluation of different ...
  • Hos seinalipour, S.M., Mujumdar, A.S., 1997, Flow and thermal characteristics ...
  • . Shiravi, A. H; Mujumdar, A. S.; Kubes, G J. ...
  • Durbin, P.A. 1991, Near-wall turbulence closure modeling without damping functions. ...
  • Moran, A.G. 2004, Predliction of the Axsymmetric Impinging Jet with ...
  • Walker, C.E. 1989, Impingement OVen technology: Part II. Applications and ...
  • Henke, M.C. 1984, Air impingement technology. In G. Glew, Advances ...
  • Millsap, S.; Marks, B.P. 2004, C ondens ing-convective boundary conditions ...
  • Xue, J., on baking in an electrically heated air jet ...
  • Kokko, T. Lautala, P.; Huhtelin, T. 2003, Advanced Control Strategy ...
  • Polat, S. 1993, Heat and mass transfer in impingement drying, ...
  • Lou, Z.Q.; Mujumdar, A.S.; Yap, C. 2005, Effects of geometric ...
  • Zhao, W.; Kumar, K.; Mujumdar, A.S. Flow and het transfer ...
  • Shi Y.L.; Mujumdar, A.S.; Ray, M.B. Numerical study on the ...
  • Shi, Y.L.; Mujumdar, A.S.; Ray, M.B. 2004, Effect of large ...
  • نمایش کامل مراجع