Determination Of Length To Diameter Ratio In TorsionalSplit Hopkinson Bar
محل انتشار: کنفرانس دو سالانه بین المللی مکانیک جامدات تجربی
سال انتشار: 1392
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 1,221
فایل این مقاله در 11 صفحه با فرمت PDF قابل دریافت می باشد
- صدور گواهی نمایه سازی
- من نویسنده این مقاله هستم
استخراج به نرم افزارهای پژوهشی:
شناسه ملی سند علمی:
WMECH02_018
تاریخ نمایه سازی: 21 تیر 1393
چکیده مقاله:
Split Hopkinson bar (SHB) is a well-known device for mechanical characterization of materials under dynamic loading. The device can be compressive, tensile, torsional or shear. The effect of dimensions of SHB in particular the length to diameter ratio, L/d, of the bars has been the subject of numerous investigations over the past several decades. However, little work has so far been performed on the forgoing ratio in torsional Hopkinson bar (TSHB). In this work, the length to diameter ratio of the input or output bar, L/d, is studied by numerical simulation and theory through Lagrange diagram of the TSHB. It is found that for L/d>80, the incident, reflected and transmitted wave lengths obtained fromsimulations and Lagrange diagram are the same. This value of L/d is quite consistent with that usually recommended for compressive and tensile versions of SHB. The numerical model of TSHB is validated by Lagrange diagram and experiment.
کلیدواژه ها:
نویسندگان
G.H Majzoobi
Professor
K Rahmani
PhD Student
S Lahmi
MSc, Department of Mechanical Engineering, Bu-Ali Sina University,Hamedan ,Iran
مراجع و منابع این مقاله:
لیست زیر مراجع و منابع استفاده شده در این مقاله را نمایش می دهد. این مراجع به صورت کاملا ماشینی و بر اساس هوش مصنوعی استخراج شده اند و لذا ممکن است دارای اشکالاتی باشند که به مرور زمان دقت استخراج این محتوا افزایش می یابد. مراجعی که مقالات مربوط به آنها در سیویلیکا نمایه شده و پیدا شده اند، به خود مقاله لینک شده اند :