Numerical Simulation of the R/C Beams Strengthened by FRP Strips by NSM Method

سال انتشار: 1389
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 1,472

فایل این مقاله در 5 صفحه با فرمت PDF قابل دریافت می باشد

استخراج به نرم افزارهای پژوهشی:

لینک ثابت به این مقاله:

شناسه ملی سند علمی:

COMPOSIT02_171

تاریخ نمایه سازی: 24 مهر 1389

چکیده مقاله:

Reinforced concrete flexural elements may be required to strengthen during their service life due to various reasons, e.g. defect or decay in mechanical materials properties, imperfections on construction, or increasing of design loads due to changing in utilization or rules of the codes. Various FRP products – as composite materials- are recently used in different technique to strengthen the structural elements. In a very newest technique, which is called Near- Surface-Mounted (NSM) method, the FRP strips (or rods) are laid up on the epoxy filled grooves which already created on the external surfaces (top or bottom) of the concrete beams or slabs. Compare to traditional use of FRP sheets adhering to the external surfaces, this method cause better transferring of the loads to the surrounding concrete by enhancing the bonding stresses, as well as better protecting the mechanical properties of the FRP strips against any environmental defects. In this study, behavior of fifteen reinforced concrete beams (in three groups of different reinforcing ratios) which already strengthened by FRP strips (by NSM method), were simulated numerically by Finite Element Method. The numerical results were compared to the experimental ones. Results show impressive compatibility between the numerical and the experimental loaddisplacement curves from the initial stage of loading, up to the peak load and further down to total strength degradation. Crack pattern and deformation, and also the failure process, all reproduced in a good and reasonable estimate of the experimental results. Increase in strength along with decrease in ductility was shown by both results. Strength and stiffness of all the strengthened beams were higher compare to the control beams (with no FRP), the same as observed in the experiments. Also, it shown that for the specimens with higher reinforcements, increase in CFRP layers resulted lesser effect in strength, the same trend in the experiments.

نویسندگان

M.S Karimi

Associated professor, School of Civil Eng., Semnan University, Semnan, Iran.

M Nasseri

Graduated Student, School of Civil Eng., Semnan University, Semnan, Iran.

E Maroofi

Graduated Student, School of Civil Eng., Semnan University, Semnan, Iran

مراجع و منابع این مقاله:

لیست زیر مراجع و منابع استفاده شده در این مقاله را نمایش می دهد. این مراجع به صورت کاملا ماشینی و بر اساس هوش مصنوعی استخراج شده اند و لذا ممکن است دارای اشکالاتی باشند که به مرور زمان دقت استخراج این محتوا افزایش می یابد. مراجعی که مقالات مربوط به آنها در سیویلیکا نمایه شده و پیدا شده اند، به خود مقاله لینک شده اند :
  • Yost Joseph Robert, Shawn P. Gross, David W. Dinehart, and ...
  • Taljsten, B. (1994). Plate bonding: Strengthening of existing concrete structures ...
  • نمایش کامل مراجع