Designing and Fabrication of Switching High Voltage Power Supply for Nuclear Medicine Imaging Systems

This paper describes design considerations of the High voltage (HV) module with low ripple and good stability in order to improve the efficiency of nuclear imaging systems consist of Single Photon Emission Computed Tomography (SPECT). In the design of the current HV module, push-pull topology is preferred, due to the fact; it has a better efficiency in comparison with other technologies. The module receives a positive continuous voltage about 5-8 V as input, and provides a programmable positive or negative continuous voltage from 800-2500 V as output for a total load of 200-KΩ. The ripple of the output voltage is 10 mV that it is measured by laboratory equipments and safe high voltage (SHV) probe. The measured output power in the designed module is 25 W. Experiment results show that minimum efficiency at full load is around 65%. The proposed HV module shows a good stability, low ripple (noise), fast rise time. So, it can be used in SPECT or gamma camera imaging system to provide the constant voltage for PMTS.

کلیدواژه ها:

High Voltage ، Stability ، Efficiency ، SPECT Systems ، Voltage Ripple