Numerical analysis of material flow during friction stir spot welding

سال انتشار: 1394
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 484

فایل این مقاله در 6 صفحه با فرمت PDF قابل دریافت می باشد

استخراج به نرم افزارهای پژوهشی:

لینک ثابت به این مقاله:

شناسه ملی سند علمی:

ELEMECHCONF03_0510

تاریخ نمایه سازی: 9 مرداد 1395

چکیده مقاله:

Finite element method (FEM) is used for simulation of material flow during friction stir spot welding (FSSW). Point tracking technique is applied to specify flow direction of each part of workpiece materials during welding. Simulation has been done using DEFORM-3D commercial software. Points has been taken under pin back surface in three layers. Top surface of upper sheet, interface of two sheets and deep in lower sheet. Material flow is analyzed both in radial and tool plunge direction. Results indicates that material flow is complicated and it differs in different zones. Generally, upper sheet materials displacement is more than lower sheet. Materials that are on top surface of upper sheet move up to bottom of keyhole and then be extruded upward. Materials that are deep in lower sheet have minimum flow and then minimum effect on mixing and welding. Interface materials flow is like surface material with lower displacement. On Interface, materials of lower sheet move upward and mix with upper sheet material.

کلیدواژه ها:

نویسندگان

Moosa Sajed

Mechanical Engineering Department, Azarbaijan Shahid Madani University, Tabriz, Iran

مراجع و منابع این مقاله:

لیست زیر مراجع و منابع استفاده شده در این مقاله را نمایش می دهد. این مراجع به صورت کاملا ماشینی و بر اساس هوش مصنوعی استخراج شده اند و لذا ممکن است دارای اشکالاتی باشند که به مرور زمان دقت استخراج این محتوا افزایش می یابد. مراجعی که مقالات مربوط به آنها در سیویلیکا نمایه شده و پیدا شده اند، به خود مقاله لینک شده اند :
  • M. Sajed, M. Sedighpour, A. Rasuli, and H. Daneshpour, " ...
  • H. Badarinarayan, Y. Shi, X. Li, and K. Okamoto, "Effect ...
  • M. Sajed and H. Bisadi, "Experimental failure study of friction ...
  • Y. Tozaki, Y. Uematsu, and K. Tokaji, "Effect of tool ...
  • R. Rai, A. De, H. Bhadeshia, and T. DebRoy, "Review: ...
  • S. Sattari, H. Bisadi, and M. Sajed, "Mechanical Properties and ...
  • نمایش کامل مراجع