Size Effect, Fracture Toughness, and Process Zone in Numerical Simulation of Rock Fracture

سال انتشار: 1391
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 954

فایل این مقاله در 8 صفحه با فرمت PDF قابل دریافت می باشد

استخراج به نرم افزارهای پژوهشی:

لینک ثابت به این مقاله:

شناسه ملی سند علمی:

ICCE09_1420

تاریخ نمایه سازی: 7 مهر 1391

چکیده مقاله:

A bonded particle model is used in three point bending simulation of rock fracture to investigate whether size of fracture process zone is an intrinsic material property. Different sample sizes are used. The normal bond between particles at contact points is assumed to follow a softening behavior. The slope of the linear softening is considered a material property. An extensive numerical analysis is conducted to obtain the nominal tensile strength, apparent fracture toughness, and width of the process zone. It is shown that the apparent fracture toughness is a function of the specimen size and that the change in nominal tensile strength with specimen size can be captured by Bazant’s size effect law. In addition, the numerical results suggest that inverse of width of crack tip process zone has a linear relationship with inverse of specimen size. The numerical results show a stronger relationship between width of process zone and specimen size for a material with a small brittleness number. On the other hand, for a more brittle material, specimen size has a small or no impact on size of process zone; process zone can be considered a material property when the brittleness number is greater than 10.

نویسندگان

Ali Tarokh

Graduate student, Department of Mineral Engineering, New Mexico Tech, Socorro

Ali Fakhimi

Professor and corresponding author, Department of Mineral Engineering, New Mexico