Shaping Flat Conductor Plates to Reduce the RCS

سال انتشار: 1391
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 1,331

متن کامل این مقاله منتشر نشده است و فقط به صورت چکیده یا چکیده مبسوط در پایگاه موجود می باشد.
توضیح: معمولا کلیه مقالاتی که کمتر از ۵ صفحه باشند در پایگاه سیویلیکا اصل مقاله (فول تکست) محسوب نمی شوند و فقط کاربران عضو بدون کسر اعتبار می توانند فایل آنها را دریافت نمایند.

استخراج به نرم افزارهای پژوهشی:

لینک ثابت به این مقاله:

شناسه ملی سند علمی:

ICEEE04_096

تاریخ نمایه سازی: 6 مهر 1391

چکیده مقاله:

In this paper, we try to reduce the radar cross section (RCS) of a flat conductor plate by shaping it. Using this method, the disadvantages of using absorber will disappear. For this purpose, we define a function for describing this roughness and apply this function to the plate. The height profile will be considered as a two variables function z=f(x,y) which is describes the height of the roughness. We consider this function as a series of cosine terms . The structure analysis and the RCS calculation are done using integral equations. These equations are solved with the use of numerical methods in MATLAB. To finding a proper function, we utilize Genetic Algorithm optimization method for finding the coefficient of each term of series. Finally, a design is presented and the effectiveness of this method is shown.

کلیدواژه ها:

radar cross section reduction ، shaping ، integral equation ، method of momen

نویسندگان

Rahman Sofiani

Electrical Eng. DepartmentIran University of Science and TechnologyTehran, Iran

M.Khalaj Amirhosseini

Electrical Eng. DepartmentIran University of Science and TechnologyTehran, Iran