Development of Setup-free Machining Technology of Plate-like Components (Software & Hardware)
سال انتشار: 1384
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 1,606
فایل این مقاله در 8 صفحه با فرمت PDF قابل دریافت می باشد
- صدور گواهی نمایه سازی
- من نویسنده این مقاله هستم
استخراج به نرم افزارهای پژوهشی:
شناسه ملی سند علمی:
ICME07_014
تاریخ نمایه سازی: 6 آذر 1388
چکیده مقاله:
Traditionally, workpiece holding fixtures have been designed and fabricated only for mass production whereby high lead-time and high cost of fixture design and preparation is justified through huge amount of parts which have been produced. New tendency toward manufacturing of low-volume, high-repetitive products compels manufacturing engineers to modify conventional opinion of fixture design for lowvolume production in order to minimize and if possible eliminate design and preparation of fixtures. A new technology of machining plate like components is represented in this paper and its possibility is validated through a practical test.
نویسندگان
M Rahi
M.S. Student of Mazandaran University
Muhammad Shakeri
Associate Prof University of Mazandaran, Faculty of MechanicalEngineering,
M Bakhshi
Associate Prof.