Static Rigid Force Model for 3- Axis Ball-end Milling Of Sculptured Surfaces

سال انتشار: 1384
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 1,322

فایل این مقاله در 11 صفحه با فرمت PDF قابل دریافت می باشد

استخراج به نرم افزارهای پژوهشی:

لینک ثابت به این مقاله:

شناسه ملی سند علمی:

ICME07_050

تاریخ نمایه سازی: 6 آذر 1388

چکیده مقاله:

Static rigid force model is used to estimate cutting forces of sculptured surface in an straightforward way, without considering tool deflection, machine tool dynamic behavior and any vibration effects. Two programs were used for calculations, “ACIS” the 3-D geometric modeler and “VISUAL BASIC”. Two programs were edited and used to preform the calculations, the scheme program to model the work piece ,tool and cutting edge and to obtain the geometric data and the VISUAL BASIC program designe to use ACIS geometric data to calculate the cutting forces. The engaged part of the cutting edge and work piece is divided into small differential oblique cutting edge segments. Friction, shear angles and shear stresses are identified from orthogonal cutting data base available in literature. The cutting force components, for each tool rotational position, are calculated by summing up the differential cutting forces. Laboratory tests were conducted to verify the Predictions of the model. The work pieces were prepared from CK45 steel using an insert type ball-end cutter. No coolant was used in any of the experimental works. The cutting forces predicted have shown good agreement with experimental results.

نویسندگان

M.H Sadeghi

Associated professor of Mechanical Engineering Department, TMU University, Tehran, Iran

R Salami

Assistant Professor of Mechanical Engineering Department, Azad University Semnan branch, Semnan, Iran

A Abdollah

Manufacturing Engineering Group, MechanicalEngineering Department,Tarbiat Modarres University, Tehran, Iran