Some Numerical and Experimental Studies on the Indentation Forging of Thick- Walled Tubes

سال انتشار: 1384
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 1,474

فایل این مقاله در 8 صفحه با فرمت PDF قابل دریافت می باشد

استخراج به نرم افزارهای پژوهشی:

لینک ثابت به این مقاله:

شناسه ملی سند علمی:

ICME07_087

تاریخ نمایه سازی: 6 آذر 1388

چکیده مقاله:

Indentation forging process is used for internal forming and sizing of thick-walled tubes designed to withstand high internal pressures. In this process, a mandrel with a diameter slightly larger than that of the tube is pressed inside the tube and in so doing, creates the internal profile. This paper presents an experimental and numerical study of this process. 2D Axisymmetric FEM analysis is used to investigate the effects of process parameters. Experiments are carried out to validate the numerical results.

نویسندگان

R.A Bihamta

M.Sc, Graduate Research Engineer, Sharif University of Technology

M.R Movahhedy

Assistant Professor, Sharif University of Technology

A.R Mashreghi

Assistant Professor, University of Yazd

مراجع و منابع این مقاله:

لیست زیر مراجع و منابع استفاده شده در این مقاله را نمایش می دهد. این مراجع به صورت کاملا ماشینی و بر اساس هوش مصنوعی استخراج شده اند و لذا ممکن است دارای اشکالاتی باشند که به مرور زمان دقت استخراج این محتوا افزایش می یابد. مراجعی که مقالات مربوط به آنها در سیویلیکا نمایه شده و پیدا شده اند، به خود مقاله لینک شده اند :
  • Michaeal J.Iremonge, Gurdip S. Kalsi, A Numerical Study of Swage ...
  • C.G.C. Poussard, M.J.Pavier, D.J.Smith, Prediction of Residual Stresses in Coldworked ...
  • N.R.Chitkara, A.Aleem, Extrusion of axi-symmetric tubes from hollow and solid ...
  • Tehran International Congress on Man ufacturing Engineering (TICME2005) December 12-15, ...
  • Tehran International Congress on Man ufacturing Engineering (TICME2005) December 12-15, ...
  • Tehran International Congress on Man ufacturing Engineering (TICME2005) December 12-15, ...
  • نمایش کامل مراجع