Effects of Machining Parameters on Cutting Force and Surface Roughness of the Superalloy Inconel 738

سال انتشار: 1386
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 2,167

فایل این مقاله در 7 صفحه با فرمت PDF قابل دریافت می باشد

استخراج به نرم افزارهای پژوهشی:

لینک ثابت به این مقاله:

شناسه ملی سند علمی:

ICME08_096

تاریخ نمایه سازی: 27 آبان 1388

چکیده مقاله:

This research represents an investigation on the effects of machining parameters such as feed rete, spindle speed and depth of cut on surface roughness and cutting force of hard-to-cut superalloy Inconel 738 in turning process. Inconel 738 has high strength at elevated temperature which makes it attractive toward various applications in aerospace industry and land-base turbines.A L32 Taguchi standard orthogonal array was used as the design of experiment (DOE). The level of importance of the machining parameters on Ra and force were determined by analysis of variance (ANOVA). Eventually the optimum of the effective parameter combinations were obtained by using the analysis of signal to noise(S/N).

کلیدواژه ها:

نویسندگان

A Farhadi

Gratuate student-Isfahan University of Technology

A.F Tehrani

Assist.prof-Isfahan University of Technology

M.J Haddad

Phd.Student-Tarbiat Modares University

A.A Mohammadi

Lecturer-Isfahan University of Technology

مراجع و منابع این مقاله:

لیست زیر مراجع و منابع استفاده شده در این مقاله را نمایش می دهد. این مراجع به صورت کاملا ماشینی و بر اساس هوش مصنوعی استخراج شده اند و لذا ممکن است دارای اشکالاتی باشند که به مرور زمان دقت استخراج این محتوا افزایش می یابد. مراجعی که مقالات مربوط به آنها در سیویلیکا نمایه شده و پیدا شده اند، به خود مقاله لینک شده اند :
  • M. Field, Machining Aerospace Alloys, Iron and Stel Institute, Special ...
  • P. Warburton, Problems of Machining Nickel-Based Alloys, Iron and Ste! ...
  • C.T. Sims, W.C. Hagel, The Superalloys, Wiley, New York, 1972. ...
  • N. Richards, D. Aspinwall, Use of cerammic toos for machining ...
  • C.H. White, Nickel Base Alloys, Wiggin Alloy. ...
  • E.O.Ezugwu, Z.M.Wang, "The mach inabilityof nickel-based alloys: a review", Journal ...
  • H.Park, Robust design _ analysis for quality engineering, 1 st ...
  • M.S.Phadke, Quality engineering using robust design, Prentic Hall Int. Inc., ...
  • نمایش کامل مراجع