Process Optimization in Deep Drilling

سال انتشار: 1386
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 1,578

فایل این مقاله در 7 صفحه با فرمت PDF قابل دریافت می باشد

استخراج به نرم افزارهای پژوهشی:

لینک ثابت به این مقاله:

شناسه ملی سند علمی:

ICME08_254

تاریخ نمایه سازی: 27 آبان 1388

چکیده مقاله:

Chatter vibration in deep drilling is investigated. A model is prepared to define the stability lobs according to feed rate and spindle speed. Then a detailed discussion for finding ways of performing faster operation is done. Effects of tool length on chatter stability lobs are determined, and then different process optimization methods due to this parameters are investigated. It was shown that step drilling with different tool lengths is a good way to avoid regenerative chatter and do the operation faster.

نویسندگان

I Maleki

M.S. student of mechanical engineering

N. M. Noori

Assistant professor of mechanical engineering

R Madooliat

Assistant professor of mechanical engineering

A Shienejad

M.S. student of mechanical engineering

مراجع و منابع این مقاله:

لیست زیر مراجع و منابع استفاده شده در این مقاله را نمایش می دهد. این مراجع به صورت کاملا ماشینی و بر اساس هوش مصنوعی استخراج شده اند و لذا ممکن است دارای اشکالاتی باشند که به مرور زمان دقت استخراج این محتوا افزایش می یابد. مراجعی که مقالات مربوط به آنها در سیویلیکا نمایه شده و پیدا شده اند، به خود مقاله لینک شده اند :
  • D. G. Lee , H. Y. Hwang, J. K. Kim, ...
  • S. Ema , E. Marui, Suppression of chatter vibration of ...
  • Etsua Marui, Satoshi Ema, Masatoshi Hash i moto, Yasunori Wakasava, ...
  • S. Ema, E. Marui, Theoretical analysis on chatter vibration in ...
  • S. Ema, E. Marui, Suppression of chatter vibration in drilling, ...
  • , 846.46 7, 517.42 7, 624.15 ...
  • , 077.48 8, 848.09 9, 832.34 ...
  • نمایش کامل مراجع