Achieving Nanograin size In AZ31 Mg Alloy by Submerge Friction Stir Processing

سال انتشار: 1387
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 1,449

متن کامل این مقاله منتشر نشده است و فقط به صورت چکیده یا چکیده مبسوط در پایگاه موجود می باشد.
توضیح: معمولا کلیه مقالاتی که کمتر از ۵ صفحه باشند در پایگاه سیویلیکا اصل مقاله (فول تکست) محسوب نمی شوند و فقط کاربران عضو بدون کسر اعتبار می توانند فایل آنها را دریافت نمایند.

استخراج به نرم افزارهای پژوهشی:

لینک ثابت به این مقاله:

شناسه ملی سند علمی:

ICNN02_151

تاریخ نمایه سازی: 27 شهریور 1391

چکیده مقاله:

Friction stir processing (FSP) has been established as significant grain refinement technique [1]. Also FSP has been demonstrated to be an effective means of refining grain size of cast or wrought aluminum based via dynamically recrystallization. . Success FSP of Mg –based alloys refining the microstructure of the alloys down to 1-5 μm have been widely reported recently [2-4]. For Mg or solute solution hardened Mg alloys with a low content of alloying element , it is difficult to achieve a UFG microstructure due to grain growth of the single – phase grains [5]. In this study submerge FSP is used to prepare nano grain AZ31 Mg alloys. With just single pass under effective cooling and suitable parameters process, the mean grain size of the obtained specimen can be refined to an nano grain (200-500) which is much finer than previous SPD result[6]. The working temperature and strain rate, combined and expressed by Zener-Holloman parameter

نویسندگان

A Shahnam

department of material science, Isfahan University of technology, P.O.۸۴۱۵۶ , Iran,Isfahan