Numerical analysis of residual stresses and crack propagationin welded tubular X-joint subject to OPB loading

سال انتشار: 1395
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 570

فایل این مقاله در 15 صفحه با فرمت PDF قابل دریافت می باشد

استخراج به نرم افزارهای پژوهشی:

لینک ثابت به این مقاله:

شناسه ملی سند علمی:

ICRSIE01_065

تاریخ نمایه سازی: 25 آذر 1395

چکیده مقاله:

Welded joints are widely used in the construction of offshore platforms. The large residual stress is generally caused by welding process in welded components. In this research, the finite element 3D modeling of welded tubular X-joint with 3-passes, made of St52, is down by ABAQUS software and welding residual stresses produced in the welding surrounding area have been estimated. In the modeling was performed for tubular X-joint and electrodes, the mechanical and thermal properties as a function of temperature as input is considered, and with respect to the electrode voltage and speed, heat flux at boiling temperature until the ambient temperature is calculated and ultimate remaining stress in the body at the end of the process of heat exchange with the environment, are residual stresses. The modeling results were good agreement with experimental results and using of this software can be a good estimate of the results achieved. Based on 3D modeling, the residual stresses in the longitudinal, transverse and shear residual stresses than acceptable results with experimental data show. Also, the results of numerical simulation and results of laboratory measurements for crack propagation have been compared together and good compatibility has been achieved.

نویسندگان

Nabard Habibi

Assistant professor, Mechanical Engineering Department, University of Kurdistan, Sanandaj, Iran,

Homayoon Kalantari-Moghadam

Master Science, Mechanical Engineering Department, University of Kurdistan, Sanandaj, Iran

مراجع و منابع این مقاله:

لیست زیر مراجع و منابع استفاده شده در این مقاله را نمایش می دهد. این مراجع به صورت کاملا ماشینی و بر اساس هوش مصنوعی استخراج شده اند و لذا ممکن است دارای اشکالاتی باشند که به مرور زمان دقت استخراج این محتوا افزایش می یابد. مراجعی که مقالات مربوط به آنها در سیویلیکا نمایه شده و پیدا شده اند، به خود مقاله لینک شده اند :
  • Yaghi A, Becker A. State of the art Review-Weld Simulation ...
  • Bhuyan GS, Arockiasamy M, Analysis of Tubular Joint with Weld ...
  • Borges L, Chiew SP, Asce M, Nussbaumer A, Asce M, ...
  • Yuan Cheng P, Influence of Residual Stress and Heat Affected ...
  • Barsoum Z, Residual Stress Prediction and Relaxation in welded tubular ...
  • Nadimi Bavil Oliaei S, Naghinazhad Ahmadi P, Rohani B, Finite ...
  • Rashid MM, Tvergaard V, Crack trajectory near a weld: Modeling ...
  • Gupta A, Experimental investigation of effect of Residual Stresses on ...
  • Sonsino CM, Effect of residual stresses on the fatigue behavior ...
  • Radaj D, Heat effect of welding- temperature fields, residual stres ...
  • Barthelemy JY, Structural Integrity Assessment Procedures for European Industry, Sintap, ...
  • Hicks J, Welded design-theory and practice, first published 2000. Abington ...
  • Farrahi GH, Majzoobi GH, Habibi N, Fatigue Life of Shot ...
  • Internationa Conference on researches in Science and Engineering 28 July ...
  • Proceedings of the World Congress on Engineering, Vol III WCE ...
  • Habibi N, Hairan M, Farrahi GH, Majzoobi GH, Mahmoudi AH, ...
  • Habibi N, H-Gangaraj SM, Farrahi GH, Majzoobi GH, Mahmoudi AH, ...
  • Farrahi GH, Majzoobi GH, Habibi N, Fatigue life of repaired ...
  • Fricke S, Keim E, Schmidt J, Numerical weld modeling-a method ...
  • P anagiotopoulo _ Gourge D, A Finite Element Procedure for ...
  • Chattopadhyay A, Glinka G, El-Zein M, Qian J, Formas R, ...
  • Habibi N, Fatigue Analysis of repaired welded joints. PHD Thesis, ...
  • Barsoum Z, Barsoum L, Residual stres effects _ fatigue life ...
  • Barsoum Z, Residual Stress Analysis and Fatigue Assessment of Welded ...
  • Barsoum Z, Lundback A, Simplified FE welding simulation of fillet ...
  • Goldak JA, Chakravati A, Bibby M, A new finite element ...
  • Dowling NE, Mechanical Behavior of Materials. fourth edition, Prentice-Hall, 2012. ...
  • نمایش کامل مراجع