Hydraulics Investigation of Mesh Panel Bottom Racks Using a Physical Model

سال انتشار: 1393
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 608

فایل این مقاله در 12 صفحه با فرمت PDF قابل دریافت می باشد

استخراج به نرم افزارهای پژوهشی:

لینک ثابت به این مقاله:

شناسه ملی سند علمی:

ICSAU02_0317

تاریخ نمایه سازی: 16 خرداد 1394

چکیده مقاله:

Bottom racks are metal structures which are installed at channel intakes in order to drain surface waters in urban areas. They can also be used as intakes in mountainous rivers with high slopes and coarse grained bed loads. One type of bottom racks that has received little attention so far is the bottom rack built with a network of longitudinal and transversal bars which has a better performance against applied forces. This specific form which is called mesh panel bottom rack was considered in this paper. Accordingly, for the present study three mesh panel bottom racks with different void ratio were built and installed in a flume with different slopes. A total series of 81 experiments with different discharge rates of clear water and different lengths of the bottom racks were conducted.In every experiment, the discharge diverted by the rack and the discharge remaining in diverted canal were measured by a sharp crested rectangular weir. Subsequently, variations of discharge coefficient for this type of bottom rack were tested under different hydraulic and geometrical parameters. To do so, first the general normalized relation was extracted using dimensional analysis. Then, in order to determine the coefficients of the relation, between the data collected from the 81 experiments, regression analysis was carried out on different relations and finally the best relation was chosen based on present statistical criteria. Finally, hydraulically performance of mesh panel bottom racks were compared with longitudinal bar bottom racks through calculation of diverted discharge byeach type in the same hydraulic and geometric conditions.

کلیدواژه ها:

bottom rack intake ، dimensional analysis ، fitting ، spatial varied flow with decreasing discharge ، discharge coefficient

نویسندگان

Keivan Bina

Assistant Professor of Civil Engineering, Khavaran Institute of Higher Education, Mashhad, Iran,

M. R. Akhavan Abdollahian

Ph.D. Student of Geography and Urban Development, Isfahan University, Isfahan, Iran, Faculty Member of Khavaran Institute of Higher Education

مراجع و منابع این مقاله:

لیست زیر مراجع و منابع استفاده شده در این مقاله را نمایش می دهد. این مراجع به صورت کاملا ماشینی و بر اساس هوش مصنوعی استخراج شده اند و لذا ممکن است دارای اشکالاتی باشند که به مرور زمان دقت استخراج این محتوا افزایش می یابد. مراجعی که مقالات مربوط به آنها در سیویلیکا نمایه شده و پیدا شده اند، به خود مقاله لینک شده اند :
  • Andaroodi M., (2005), _ S tandardization of Civi] Engineering Works ...
  • Orth, J., E. Chardonnet, G. Meynardi, (1954), "Etude de Grilles ...
  • Kuntzmann, J. and M. Bouvard (1954) "Etude Theorique des Grilles ...
  • Drobir H., (1981), "Entwurf von Was serfassungen im Hochgebirge" Osterr, ...
  • Subramanya K. Shukla S. K. (1988), "Discharge Diversion Characteristics of ...
  • Brunella S., Hager W. H., Minor H. E. (2003), "Hydraulics ...
  • Hosseini, S, M., and Abrishami, ) (2007). Open channel hydraulics." ...
  • Shafaei Bajestan, S. M., and Shokohirad, Gh. (1997). "Experimental investigation ...
  • Razaz, M., and Faghfor Maghrebi, M. (2008). "Experimental and numericat ...
  • Calculation of developing :ه [11] Bonakdari, H., Zinatizadeh Lorestani, A., ...
  • Forghani Alahabadi, R. (1995). "Investigation of effective parameters _ bottom ...
  • Heydari Nezhad, Gh. (1997). Physical and hydraulic models, _ Chamran ...
  • Esmaeliyan, M. (2005). Handbook of SPSS12, _ Pub., Tehran, Iran. ...
  • Rezayi, M., and Soltani, A. _ Introduction o applied regression ...
  • Bitz Duglos, M. (2002). Non-Linear Regression analysis, Ferdowsi University of ...
  • Faghfour Maghrebi, M., and Rezai nasab, M.S. (2005). "Discharge estimation ...
  • نمایش کامل مراجع