INVESTIGATION OF Cr EFFECT ON THE MICROSTRUCTURE AND TENSILE PROPERTIES OF AL-12Zn-2.5Mg-2.5Cu ALUMINUM ALLOY

سال انتشار: 1391
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 1,161

فایل این مقاله در 11 صفحه با فرمت PDF قابل دریافت می باشد

استخراج به نرم افزارهای پژوهشی:

لینک ثابت به این مقاله:

شناسه ملی سند علمی:

IMES06_048

تاریخ نمایه سازی: 8 بهمن 1391

چکیده مقاله:

In this study, the effect of Cr on the microstructure and tensile properties of Al-12Zn-2.5Mg-2.5Cu-0.05Ti aluminum alloy has been investigated. Microstructural examinations were performed byoptical and scanning electron microscopy, coupled with energy dispersive spectrometry. Microstructural studies showed that by adding Cr (from 0 to 5 wt. %) to the alloy, the volume fraction of precipitates in the matrix increases. Also, increasing Cr content showed an increase in ultimate tensile strength (UTS) values and marginal effect on ductility (% El.). The optimum amount of Cr was obtained. SEM fractography of fractured surfaces showed an overall brittle appearance with cracking along the grains and in the precipitates

نویسندگان

Nima mossayebi

M. Sc. Student, School of Metallurgy and Materials, School of engineering,University of Tehran

Masoud Emamy

Professor, School of Metallurgy and Materials, School of engineering, University of Tehran.

Jafar Rassizdehghani

Associate professor, School of Metallurgy and Materials, School of engineering, University of Tehran

مراجع و منابع این مقاله:

لیست زیر مراجع و منابع استفاده شده در این مقاله را نمایش می دهد. این مراجع به صورت کاملا ماشینی و بر اساس هوش مصنوعی استخراج شده اند و لذا ممکن است دارای اشکالاتی باشند که به مرور زمان دقت استخراج این محتوا افزایش می یابد. مراجعی که مقالات مربوط به آنها در سیویلیکا نمایه شده و پیدا شده اند، به خود مقاله لینک شده اند :
  • I1] E. A. Starke Jr., J. T. Staley, "Application of ...
  • Y. L. Wu, F. H. Froes, A. Alvarez, C. G. ...
  • L. Nian-kui, C. Jian-zhong, _ _ Mi crostructural evolution of ...
  • C. Mondal, A. K. Mukhop adhyay, "On the natur of ...
  • Y. Ii, P. Li, G. Zhao, X. Liu, J. Cui, ...
  • F. Xie, X. Yan, L. Ding, F. Zhang, S. Chen, ...
  • K. T. Kashyap, T. Chandrashekar, "Effects and mechanisms of grain ...
  • N. Pourkia, M. Emamy, H. Farhangi, S. H. Seyed Ebrahimi, ...
  • H. Yongdong, Z. Xinming, C. Zhiqiang, "Effect of Minor Cr, ...
  • D. N. Compton, L. A. Cornish, M. J. Witcomp, "The ...
  • X. M. Li, M. J. Starink, "Identificatio and analysis of ...
  • G. Y. Lin, Z. F. Zhang, H. Zhang. D. S. ...
  • P. Z. Zhao, T. Tsuchida, "Effect of fabrication conditions and ...
  • O. E. Osintsev, V. Yu. Konkevich, S. Ya. Betsofen, "Hardening ...
  • S. H. seyed Ebrahimi, M. Emamy, "Effects of Al-5Ti-1B and ...
  • K. Mahdouk, J. C. Gachon, "Thermo dynamic Investigation of the ...
  • M. Tiryakioglu, J. T. Staley, "Physical Metallurgy and the Effect ...
  • نمایش کامل مراجع