Load and Stress Analysis of Cylindrical Worm Gearing using Tooth Slicing Method

سال انتشار: 1384
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 2,055

فایل این مقاله در 9 صفحه با فرمت PDF قابل دریافت می باشد

استخراج به نرم افزارهای پژوهشی:

لینک ثابت به این مقاله:

شناسه ملی سند علمی:

ISME13_642

تاریخ نمایه سازی: 21 اسفند 1385

چکیده مقاله:

A method for the determination of load and stress distributions of the instantaneously engaged teeth of cylindrical worm gears is represented in this paper. The method is based on the assumption that both the worm and gear can be modeled as a series of spur gear slices. The exact geometry and point of load application of each slice depends on its location with the mesh. By calculating the applied load and stress for each slice, the same can be determined for the entire worm gear set. The method takes into consideration tooth stiffness variation from root to tip, tooth bending deflection, local contact deformation, tooth foundation deformation and, the influence of gear parameters on load and stress. Calculated results were found to agree with experimental and analytical ones obtained from literature under given operating conditions.

نویسندگان

Elkholy

Mechanical Engineering Department Kuwait University

Falash

Mechanical Engineering Department Kuwait University

مراجع و منابع این مقاله:

لیست زیر مراجع و منابع استفاده شده در این مقاله را نمایش می دهد. این مراجع به صورت کاملا ماشینی و بر اساس هوش مصنوعی استخراج شده اند و لذا ممکن است دارای اشکالاتی باشند که به مرور زمان دقت استخراج این محتوا افزایش می یابد. مراجعی که مقالات مربوط به آنها در سیویلیکا نمایه شده و پیدا شده اند، به خود مقاله لینک شده اند :
  • '" Annual (International) Mechanical Engineering Conference - May 2005 Isfahan ...
  • Dudley, D.W. Gear handbook, the design, manufacture, and applications of ...
  • DIN. DIN 3990 - Calculation of load capacity of cylindrical ...
  • Andrews, J.D. A finite element analysis of bending stresses included ...
  • Design unit. Gear analysis software system. University of Newcastle upon ...
  • Rao, C.R.M., M uthuveerappan, G. Finite element modeling and stress ...
  • Shigley, I.E., ،Mechanical Engineering Design' 1* Metric Ed.. McGraw-Hill, New ...
  • Elkholy, A.H., ،Tooth Load Sharing in High-Contact Ratio Spur Gears', ...
  • نمایش کامل مراجع