An Experimental Investigation on Electrical Discharge Machining of DIN 1.2714 Steel
محل انتشار: چهاردهمین کنفرانس سالانه مهندسی مکانیک
سال انتشار: 1385
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 2,130
فایل این مقاله در 8 صفحه با فرمت PDF قابل دریافت می باشد
- صدور گواهی نمایه سازی
- من نویسنده این مقاله هستم
استخراج به نرم افزارهای پژوهشی:
شناسه ملی سند علمی:
ISME14_596
تاریخ نمایه سازی: 1 فروردین 1386
چکیده مقاله:
In this study, the effect of machining parameters of EDM process including on time , current, voltage, the engaging time between workpiece and electrode tool, and pre-EDM roughing on surface roughness are experimentally investigated. An appropriate standard orthogonal array is chosen using Taguchi’s method. Main effect of factors and interactions are considered in this paper and regression equation is derived. Optimal factor levels are determined by means of S/N ratio analysis. Copper is used as electrode to machine hot work tool steel 1.2714, which is widely used to make forging dies and mandrels.
کلیدواژه ها:
Electrical discharge machining - Surface roughness – Process parameters
نویسندگان
Fadaei Tehrani
Assistant Professor, Mechanical Engineering Department, Isfahan University of technology
Zarepour
Manufacturing Engineering Division, Department of Engineering
Karimi
MSc Student, Mechanical Engineering Department, Tarbiat Modarres University
Amini
Islamic Azad University, Najafabad
مراجع و منابع این مقاله:
لیست زیر مراجع و منابع استفاده شده در این مقاله را نمایش می دهد. این مراجع به صورت کاملا ماشینی و بر اساس هوش مصنوعی استخراج شده اند و لذا ممکن است دارای اشکالاتی باشند که به مرور زمان دقت استخراج این محتوا افزایش می یابد. مراجعی که مقالات مربوط به آنها در سیویلیکا نمایه شده و پیدا شده اند، به خود مقاله لینک شده اند :