Buckling of Isotropic Plates with Two Opposite Elastically Supported Edges and Other Two Edges Simply Supported Unloaded
محل انتشار: هجدهمین کنفرانس سالانه مهندسی مکانیک
سال انتشار: 1389
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 1,878
متن کامل این مقاله منتشر نشده است و فقط به صورت چکیده یا چکیده مبسوط در پایگاه موجود می باشد.
توضیح: معمولا کلیه مقالاتی که کمتر از ۵ صفحه باشند در پایگاه سیویلیکا اصل مقاله (فول تکست) محسوب نمی شوند و فقط کاربران عضو بدون کسر اعتبار می توانند فایل آنها را دریافت نمایند.
- صدور گواهی نمایه سازی
- من نویسنده این مقاله هستم
استخراج به نرم افزارهای پژوهشی:
شناسه ملی سند علمی:
ISME18_142
تاریخ نمایه سازی: 1 تیر 1389
چکیده مقاله:
In the present paper buckling of isotropic rectangular plate is considered. This problem expands the results known form literature to a special case, where the loaded edges of the plate are elastically supported. It is established, that the problems of buckling by symmetric and anti-symmetric shapes are decoupled. Then these problems are investigated based on Levy analytical method. Comparison with simply supported, elastically supported and sliding contact edges cases is provided. Obtained results, for particular limit cases of boundary conditions convergence to the results available in the literature, which serves as additional verification of the proposed analysis. The effects of change in aspect ratio of the plate and in the elastic restraint parameters on the buckling critical loads and mode shapes are illustrated in graphically.
کلیدواژه ها:
نویسندگان
Reza Sharifian
PhD. Student, Department of Mechanics, Yerevan State University
Vagharshak Belubekyan
Assistant-professor, Department of Mechanics, Yerevan State University
مراجع و منابع این مقاله:
لیست زیر مراجع و منابع استفاده شده در این مقاله را نمایش می دهد. این مراجع به صورت کاملا ماشینی و بر اساس هوش مصنوعی استخراج شده اند و لذا ممکن است دارای اشکالاتی باشند که به مرور زمان دقت استخراج این محتوا افزایش می یابد. مراجعی که مقالات مربوط به آنها در سیویلیکا نمایه شده و پیدا شده اند، به خود مقاله لینک شده اند :