Preparation of Unsaturated Polyester/PMMA Syntactic Foam and Study of the Effect of Microsphere Loading on its Density and Void Content

سال انتشار: 1391
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 306

متن کامل این مقاله منتشر نشده است و فقط به صورت چکیده یا چکیده مبسوط در پایگاه موجود می باشد.
توضیح: معمولا کلیه مقالاتی که کمتر از ۵ صفحه باشند در پایگاه سیویلیکا اصل مقاله (فول تکست) محسوب نمی شوند و فقط کاربران عضو بدون کسر اعتبار می توانند فایل آنها را دریافت نمایند.

استخراج به نرم افزارهای پژوهشی:

لینک ثابت به این مقاله:

شناسه ملی سند علمی:

ISPST10_570

تاریخ نمایه سازی: 6 اردیبهشت 1396

چکیده مقاله:

Syntactic foams are mechanical mixtures of micro balloons (hollow particles) in a matrix material. These materials are classified as closed pore foams, since the porosity in themexists in form of hollow particles. The closed pore structure gives advantages of higher strength and lower moistureabsorption coefficient compared to the opened cell ones.[1] The compressive strength of conventional foams is less than 10 MPa whereas syntactic foam have a compressive yieldstrength between 30 and 100 MPa.[2] Unsaturated polyester has many advantages such as low cost, easy to operate andgood wet ability and in this work has been used to synthesis syntactic foams by its combination with poly methyl methacrylate (PMMA) micro balloon.

نویسندگان

A.R Farmany

Faculty of polymer processing, Iran Polymer and Petrochemical Institute (IPPI), Tehran, Iran.

M Esfandeh

Faculty of polymer processing, Iran Polymer and Petrochemical Institute (IPPI), Tehran, Iran.

S.M Mirabedini

Faculty of polymer processing, Iran Polymer and Petrochemical Institute (IPPI), Tehran, Iran.

مراجع و منابع این مقاله:

لیست زیر مراجع و منابع استفاده شده در این مقاله را نمایش می دهد. این مراجع به صورت کاملا ماشینی و بر اساس هوش مصنوعی استخراج شده اند و لذا ممکن است دارای اشکالاتی باشند که به مرور زمان دقت استخراج این محتوا افزایش می یابد. مراجعی که مقالات مربوط به آنها در سیویلیکا نمایه شده و پیدا شده اند، به خود مقاله لینک شده اند :
  • N. Gupta, E. Woldesenbet; Journal of Cellular Plastics, 40, 461, ...
  • P. Bunn, J. T. Mottram; Journal of Composites. 24, 565, ...
  • hrs. The formulations of the prepared samples and the measured ...
  • ISPST2012, Amirkabir University of Technology, Tehran, Iran, 21-25 October 2012 ...
  • نمایش کامل مراجع