Effect of Raster Angle on the Mechanical Properties of PLA 3D Printed Articles
سال انتشار: 1395
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 312
متن کامل این مقاله منتشر نشده است و فقط به صورت چکیده یا چکیده مبسوط در پایگاه موجود می باشد.
توضیح: معمولا کلیه مقالاتی که کمتر از ۵ صفحه باشند در پایگاه سیویلیکا اصل مقاله (فول تکست) محسوب نمی شوند و فقط کاربران عضو بدون کسر اعتبار می توانند فایل آنها را دریافت نمایند.
- صدور گواهی نمایه سازی
- من نویسنده این مقاله هستم
استخراج به نرم افزارهای پژوهشی:
شناسه ملی سند علمی:
ISPST12_281
تاریخ نمایه سازی: 6 اردیبهشت 1396
چکیده مقاله:
Fused deposition modeling (FDM) has been emerged as the most popular additive manufacturing technologies to make the engineering components within a short span of time. In this method, 3D digital CAD data is converted directly to make a product. In the present investigation, the mechanical properties of FDM printed specimens were evaluated according to Iso- 527A-5A. The specimens were printed using PLA filament at different raster angles of 0º/90o, ±45º and 60º/-30o. It was found that the raster angle is an important parameter which significantly affected on the mechanical properties of the specimens. The results showed that the tensile strength decreased with the increase in the raster angle
کلیدواژه ها:
نویسندگان
Maryam Ezoji
Alborz Composites Eng. Co. R&D Tehran, Iran
Mohammad Razavi-Nouri
Iran Polymer and Petrochemical Institute, Tehran, Iran
Amir Masood Rezadoust
Iran Polymer and Petrochemical Institute, Tehran, Iran
مراجع و منابع این مقاله:
لیست زیر مراجع و منابع استفاده شده در این مقاله را نمایش می دهد. این مراجع به صورت کاملا ماشینی و بر اساس هوش مصنوعی استخراج شده اند و لذا ممکن است دارای اشکالاتی باشند که به مرور زمان دقت استخراج این محتوا افزایش می یابد. مراجعی که مقالات مربوط به آنها در سیویلیکا نمایه شده و پیدا شده اند، به خود مقاله لینک شده اند :