A MEMS Capacitive Microphone Modelling for Integrated Circuits

سال انتشار: 1394
نوع سند: مقاله ژورنالی
زبان: انگلیسی
مشاهده: 473

فایل این مقاله در 8 صفحه با فرمت PDF قابل دریافت می باشد

استخراج به نرم افزارهای پژوهشی:

لینک ثابت به این مقاله:

شناسه ملی سند علمی:

JR_IJE-28-6_009

تاریخ نمایه سازی: 15 آذر 1394

چکیده مقاله:

In this paper, a model for MEMS capacitive microphone is presented for integrated circuits. The microphone has a diaphragm thickness of 1 μm,0.5 × 0.5 mm2 dimension, and an air gap of 1.0 μm.Using the analytical and simulation results, the important features of MEMS capacitive microphonesuch as pull-in voltage and sensitivity are obtained as 3.8V and 6.916 mV/Pa, respectively, while there is no pressure on the diaphragm. The microphone has a capacitance of 2.3 pF. Using the relationbetween the capacitance and pressure signal, a 3 ports model for the MEMS microphone is proposed.To bias the microphone, a 2.3 V DC and a 1 GΩ resistor is used. The voltage and current signal of the microphone is proportional to the applied pressure of the acoustic wave. An RC filter is added to the circuit to eliminate the low band frequency (≤ 20 Hz) noises. The microphone shows good response to amplitude and frequency changes versus applied pressure signal

نویسندگان

j Ahmadnejad

Electrical and Computer Engineering Department, Babol Noshirvani University of Technology, Babol, Iran

b AzizollahGanji

Electrical and Computer Engineering Department, Babol Noshirvani University of Technology, Babol, Iran

a Nemati

Electrical and Computer Engineering Department, Babol Noshirvani University of Technology, Babol, Iran