Experimental Comparison the Effect of Mn2O3 and Co3O4 Nano Additives on the Performance and Emission of SI Gasoline Fueled with Mixture of Ethanol and Gasoline
محل انتشار: ماهنامه بین المللی مهندسی، دوره: 32، شماره: 5
سال انتشار: 1398
نوع سند: مقاله ژورنالی
زبان: انگلیسی
مشاهده: 357
فایل این مقاله در 8 صفحه با فرمت PDF قابل دریافت می باشد
- صدور گواهی نمایه سازی
- من نویسنده این مقاله هستم
استخراج به نرم افزارهای پژوهشی:
شناسه ملی سند علمی:
JR_IJE-32-5_019
تاریخ نمایه سازی: 10 آذر 1398
چکیده مقاله:
In this paper, the use of gasoline combinations with ethanol and nano oxide particles has been studied in gasoline-based SI EF7 engines. The mixtures are prepared in five emulsions of gasoline with 10% ethanol, gasoline with 10% ethanol and 10ppm nano Mn2O3, gasoline with 10% ethanol and 20ppm nano Mn2O3, gasoline with 10% ethanol and 10ppm nano Co3O4, gasoline with 10% ethanol and 20ppm nano Co3O4. An ultrasonic cleaner device is used to obtain a homogeneous gasoline combination with ethanol and additives of nano oxides during the test. To measure the output power of the engine, the Eddy current dynamometer has been coupled to the engine and to determine the emissions, an AVL gas analyzer is used. The results indicate that ethanol addition by 10% lead to 2.6% increase in brake power (BP), but interestingly 10 ppm Mn2O3 nano-additive raise the BP to 14.38% and 20 ppm nano-additive led to 19.56% increase of BP. While the BP with 10ppm and 20ppm nano-additives of Co3O4 has increased by 7.96% and 11.5%, respectively. With regard to emissions, ethanol presence with nano additives in the blend reduces CO, UHC, and NOx whereas increases CO2. The best blend is gasoline-10% ethanol-20ppm Mn2O3.
کلیدواژه ها:
نویسندگان
M. Amirabedia
Department of Mechanical Engineering, Faculty of Engineering, Urmia University, Urmia, Iran
S. Jafarmadar
Department of Mechanical Engineering, Faculty of Engineering, Urmia University, Urmia, Iran
S. Khalilarya
Department of Mechanical Engineering, Faculty of Engineering, Urmia University, Urmia, Iran
J. Kheyrollahi
Department of Mechanical Engineering, Faculty of Engineering, Urmia University, Urmia, Iran