An empirical study on statistical analysis and optimization of EDM process parameters for inconel 718 super alloy using D-optimal approach and genetic algorithm

سال انتشار: 1394
نوع سند: مقاله ژورنالی
زبان: انگلیسی
مشاهده: 382

فایل این مقاله در 11 صفحه با فرمت PDF قابل دریافت می باشد

این مقاله در بخشهای موضوعی زیر دسته بندی شده است:

استخراج به نرم افزارهای پژوهشی:

لینک ثابت به این مقاله:

شناسه ملی سند علمی:

JR_JCAM-46-2_014

تاریخ نمایه سازی: 21 فروردین 1397

چکیده مقاله:

Among the several non-conventional processes, electrical discharge machining (EDM) is the most widely and successfully applied for the machining of conductive parts. In this technique, the tool has no mechanical contact with the work piece and also the hardness of work piece has no effect on the machining pace. Hence, this technique could be employed to machine hard materials such as super alloys. Inconel 718 super alloy is a nickel based alloy that is mostly used in oil and gas, power stations and aerospace industries. In this study the effect of input EDM process parameters on Inconel 718 super alloy, is modeled and optimized. The process input parameters considered here include voltage (V), peak current (I), pulse on time (Ton) and duty factor (η). The process quality measures are surface roughness (SR) and material removal rate (MRR). The objective is to determine a combination of process parameters to minimize SR and maximize MRR. The experimental data are gathered based on D-optimal design of experiments. Then, statistical analyses and validation experiments have been carried out to select the best and most fitted regression models. In the last section of this research, genetic algorithm (GA) has been employed for optimization of the performance characteristics. Using the proposed optimization procedure, proper levels of input parameters for any desirable group of process outputs can be identified. A set of verification tests is also performed to verify the accuracy of optimization procedure in determining the optimal levels of machining parameters. The results indicate that the proposed modeling technique and genetic algorithm are quite efficient in modeling and optimization of EDM process parameters.

کلیدواژه ها:

Electrical Discharge Machining (EDM) ، Inconel 718 super alloy ، Optimization ، Genetic Algorithm (GA) ، Analysis of Variance (ANOVA)

نویسندگان

Masoud Azadi Moghaddam

Ph.D. Candidate, Ferdowsi University of Mashhad, Department of Mechanical Engineering, Mashhad, Iran

Farhad Kolahan

Associate Professor, Ferdowsi University of Mashhad, Department of Mechanical Engineering, Mashhad, Iran