EXPERIMENTAL AND NUMERICAL INVESTIGATION ON LASER BENDING PROCESS

سال انتشار: 1391
نوع سند: مقاله ژورنالی
زبان: انگلیسی
مشاهده: 1,004

فایل این مقاله در 8 صفحه با فرمت PDF قابل دریافت می باشد

استخراج به نرم افزارهای پژوهشی:

لینک ثابت به این مقاله:

شناسه ملی سند علمی:

JR_JCARME-1-1_005

تاریخ نمایه سازی: 17 خرداد 1393

چکیده مقاله:

Laser bending is an advanced process in sheet metal forming in which a laser heat source is used to shape the metal sheet. In this paper, temperature distribution in a mild steel sheet metal isinvestigated numerically and experimentally. Laser heat source is applied through curved paths insquare sheet metal parts. Finite element (FE) simulation is performed with the ABAQUS/CAE standard software package. Material property of AISI 1010 is used in FE model and experiments. The aim of this study is to identify the response related to deformation and characterize the effectof laser power with respect to the bending angle for a square sheet part. An experimental setup including a Nd:YAG laser Model IQL-10 with maximum mean laser power of 500 W is used for the experiments to verify FE analysis results. It is observed that numerical results are relatively in good agreement with the experimental results. Results also show that increasing laser power increases the bending angle

نویسندگان

m Hoseinpour Gollo

Department of Mechanical Engineering, Faculty of Eng., University of Mohaghegh Ardabili,P.O.Box ۱۷۳, Ardabil,Iran

h Moslemi Naeini

Department of Mechanical Engineering, Tarbiat Modarres University, Tehran. Iran

n.b Mostafa Arab

Department of Mechanical Engineering, Shahid Rajaee Teacher Training University,۱۶۷۸۸-۱۵۸۱۱,Tehran, Iran