Determination of the Mass Transfer Interfacial Area (a) During Chlorella Vulgaris Cultivation in Bubble Column Photobioreactor

سال انتشار: 1397
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 412

متن کامل این مقاله منتشر نشده است و فقط به صورت چکیده یا چکیده مبسوط در پایگاه موجود می باشد.
توضیح: معمولا کلیه مقالاتی که کمتر از ۵ صفحه باشند در پایگاه سیویلیکا اصل مقاله (فول تکست) محسوب نمی شوند و فقط کاربران عضو بدون کسر اعتبار می توانند فایل آنها را دریافت نمایند.

استخراج به نرم افزارهای پژوهشی:

لینک ثابت به این مقاله:

شناسه ملی سند علمی:

NICEC16_079

تاریخ نمایه سازی: 7 خرداد 1398

چکیده مقاله:

Mass transfer Interfacial area and gas bubble diameter are the effective parameters in bubble column reactors’ operation efficiency. In this survey the alteration of interfacial area due to changes in bubble diameter and gas hold up during cultivation of Chlorella Vulgaris in the bubble column photo bioreactor was accomplished. For measuring bubble diameters, drift flux method was used. In this method bubble diameter predicted with these parameters: gas hold up, superficial gas velocity and viscosity. With the growth of microalgae, biomass concentration could be increased and physical properties, such as liquid viscosity is ascended from 0.93 to 1.006 mPa.s. Moreover, it has the direct impression on increasing gas bubble diameter and causes a decrease of mass transfer inrefacial area about 53% and gas holdup about 58%. An experimental correlation to predict gas hold up in bubble column photo bioreactor was obtained that can predict this effective parameter on volumetric mass transfer coefficient with high accuracy (R2= 98%). This experimental correlation is on the base of superficial gas velocity, OD which is the criteria for biomass’s growth and alteration of fluid physical properties.

نویسندگان

Salar Helchi

Department of Chemical Engineering, Faculty of Engineering, University of Science and Research Branch, Islamic Azad University, Tehran, Iran

Farshid Pajoum Shariati

Department of Chemical Engineering, Faculty of Engineering, University of Science and Research Branch, Islamic Azad University, Tehran, Iran

Babak Bonakdarpour

Department of Chemical Engineering, Amirkabir University of Technology, Tehran, Iran

Hossein Delavari Amrei

Department of Chemical Engineering, University of Bojnord, Iran