Review and analysis of relation and coordination between wheel and rail hardness

سال انتشار: 1388
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 2,168

فایل این مقاله در 7 صفحه با فرمت PDF قابل دریافت می باشد

استخراج به نرم افزارهای پژوهشی:

لینک ثابت به این مقاله:

شناسه ملی سند علمی:

NMEC02_171

تاریخ نمایه سازی: 14 آبان 1388

چکیده مقاله:

In this research, we want to response to the following question by considering the current rail and wheel in Iranian railway through the measurement of wear rate between them and also by using of simulation in rail and wheel wear tester. The questions are following:What is the favorite hardness of rail and wheel?What is the ratio between hardness of rail and wheel and wear?What is the effect of increasing rail and wheel hardness in the tribologic manner?In this way, first, we provide samples of rail and wheel substances in shape of rail and wheel disc and then we do heat treatment on them for getting suitable hardness profile and microstructure. The test wear was done by wear tester of rail and wheel discs under the reduced forces(by considering test scale) of normal 897 N and lateral 193 N forces. The curve of rail and wheel disc weight decreasing was achieved by results analysis of three mentioned tests, and by their results analysis, we achieve to applied result as follow:The Iranian main lines railway is 8000 Km which 1500 Km of it is rail grade 700 and the rest of it is rail grade 900A, the wear rate of wheel by using of wheel R7 with mentioned rail(900A) is about 3 and rail is 1.5 times for normal condition. Therefore, all service wheels should be R9, because using of wheels R7 in Iranian railway causes more wear in rails and wheels.

کلیدواژه ها:

نویسندگان

M Rafiei

Department of Mechanical Engineering, Islamic Azad University, Semnan branch, Semnan, Iran.

S Aghanajafi

Department of Mechanical Engineering,K.N.Toosi University of Technology, Tehran, Iran

A Vafaeesefat

Department of Mechanical Engineering, Emam Hossein University Tehran, Iran.

S.H Yazdanitabaei

Department of Iranian Railway research center.

مراجع و منابع این مقاله:

لیست زیر مراجع و منابع استفاده شده در این مقاله را نمایش می دهد. این مراجع به صورت کاملا ماشینی و بر اساس هوش مصنوعی استخراج شده اند و لذا ممکن است دارای اشکالاتی باشند که به مرور زمان دقت استخراج این محتوا افزایش می یابد. مراجعی که مقالات مربوط به آنها در سیویلیکا نمایه شده و پیدا شده اند، به خود مقاله لینک شده اند :
  • Ki Myung Lee, Andreas A. Polycarpou, Wear of conventional pearlitic ...
  • A. Kapoor, F.J. Franklin, S.K. Wong, M. Ishida, Surface roughness ...
  • Semminar - Cum- work shop _ Excessive Rail/wheel wear And ...
  • Josepn Edward shigly, Charles R.Mischke, Mechanical Engineering Design, Mcgraw Hill, ...
  • نمایش کامل مراجع