An Asymmetrical Application of Contour Method in Measuring Residual Stresses
محل انتشار: کنفرانس دو سالانه بین المللی مکانیک جامدات تجربی
سال انتشار: 1392
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 920
فایل این مقاله در 6 صفحه با فرمت PDF قابل دریافت می باشد
- صدور گواهی نمایه سازی
- من نویسنده این مقاله هستم
استخراج به نرم افزارهای پژوهشی:
شناسه ملی سند علمی:
WMECH02_047
تاریخ نمایه سازی: 21 تیر 1393
چکیده مقاله:
Residual stresses play a significant role in many material failure processes such as fatigue, fracture, stress corrosion, cracking, buckling and distortion. Experimental methods for determining the residual stresses are divided into destructive and non-destructive techniques. Contour method is a well-known destructive technique that provides a two dimensional map of residual stresses. In this method, a part is cut in twousing a precise and low-stress cutting technique such as Electric Discharge Machining (EDM). The application of this technique mostly relies on a symmetric cut of an engineering component.In the current study, contour method was examined when the position of the cut is not symmetric. The residual stresses were measured along an asymmetrical line in quenched blocks. The process was also simulated using finite element analyses. The measurement along the asymmetrical line required a calibration technique to achieve the correct distributions of residual stresses. The measured stresses were compared with those obtained numerically.
کلیدواژه ها:
نویسندگان
A. H Mahmoudi
Assistant Professor
A Saei
M.S. Student .Mechanical Engineering Department Engineering Faculty, Bu-Ali Sina University, Hamedan, Iran
مراجع و منابع این مقاله:
لیست زیر مراجع و منابع استفاده شده در این مقاله را نمایش می دهد. این مراجع به صورت کاملا ماشینی و بر اساس هوش مصنوعی استخراج شده اند و لذا ممکن است دارای اشکالاتی باشند که به مرور زمان دقت استخراج این محتوا افزایش می یابد. مراجعی که مقالات مربوط به آنها در سیویلیکا نمایه شده و پیدا شده اند، به خود مقاله لینک شده اند :