Investigation of a Modified Stamping Process for Fabrication of PEMFC Metallic Bipolar Plates with Cascaded Flow Field

سال انتشار: 1396
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 366

متن کامل این مقاله منتشر نشده است و فقط به صورت چکیده یا چکیده مبسوط در پایگاه موجود می باشد.
توضیح: معمولا کلیه مقالاتی که کمتر از ۵ صفحه باشند در پایگاه سیویلیکا اصل مقاله (فول تکست) محسوب نمی شوند و فقط کاربران عضو بدون کسر اعتبار می توانند فایل آنها را دریافت نمایند.

استخراج به نرم افزارهای پژوهشی:

لینک ثابت به این مقاله:

شناسه ملی سند علمی:

WMECH04_031

تاریخ نمایه سازی: 11 خرداد 1397

چکیده مقاله:

Among different components of a polymer electrolyte membrane (PEM) fuel cell stack, bipolar plates are veryimportant due to their volume and weight (about 60 to 80 percent of PEM fuel cell stack) as well as cost (about 30 to 45percent of PEM fuel cell stack). In this paper, forming of complete metallic bipolar plates with cascaded serpentine flowfield and active area of 100 cm2 is investigated. For fabrication of these plates, a modified stamping process isemployed. The effect of forming forces on channel width and rib width are studied. Results reveal that an increase inthe stamping force overcomes the strain hardening, which increases the width of the channels and ribs.

کلیدواژه ها:

نویسندگان

M.M Barzegari

PhD, Fuel Cell Technology Research Laboratory, Malek Ashtar University of Technology, Fereydoonkenar, Islamic Republicof Iran

E Alizadeh

Associate Professor, Fuel Cell Technology Research Laboratory, Malek Ashtar University of Technology, Fereydoonkenar,Islamic Republic of Iran

M Khorshidian

Researcher, Fuel Cell Technology Research Laboratory, Malek Ashtar University of Technology, Fereydoonkenar, IslamicRepublic of Iran

S.H.M Saadat

Researcher, Fuel Cell Technology Research Laboratory, Malek Ashtar University of Technology, Fereydoonkenar, IslamicRepublic of Iran