Finite Element Analysis of Combined Processes of Two Severe Plastic Deformation Techniques to improve the homogeneity of the strain distribution
سال انتشار: 1399
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 751
- صدور گواهی نمایه سازی
- من نویسنده این مقاله هستم
استخراج به نرم افزارهای پژوهشی:
شناسه ملی سند علمی:
MMICONF02_006
تاریخ نمایه سازی: 7 تیر 1399
چکیده مقاله:
In most processes of severe plastic deformation, including in the aboveprocesses, the strain distribution is inhomogeneous, which causesmechanical instability in the parts. In the SSE process, the strain rate atthe center of the material is higher than the friction surfaces, whereasthis strain distribution is reversed in the CEE process. In the researchconducted by combining the SSE+CEE processes (first the SSE processand then the CEE process) and vice versa, the strain distribution issignificantly homogeneous in the sample and it can be suggested as away to obtain a homogeneous material with mechanical stability. In thisstudy, DEFORM and ABAQUS finite element software were used toobtain the strain distribution in the consumed material. The results showthat the strain distribution homogeneity factor in SSE and CEE processsamples was 1.5 and 3.8, respectively, which is 6.5 and 9.8 inCEE+SSE and SSE+CEE process that shows a significant improvementin homogeneity.
کلیدواژه ها:
نویسندگان
Saeid Nichabadi
Faculty of Mechanical Engineering, University of Guilan, Guilan, Iran
Amir Rafiee
Faculty of Mechanical Engineering, Urmia University, Urmia, Iran
Hamoun Khatami
Faculty of Mechanical Engineering, Urmia University, Urmia, Iran