effect of resistance upset welding parameters on metallurgical sturcture electrical resistivity and tensile strength of heating element 80Ni-20Cr
محل انتشار: کنگره بین المللی جوش و روشهای اتصال
سال انتشار: 1388
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 1,335
فایل این مقاله در 7 صفحه با فرمت PDF قابل دریافت می باشد
- صدور گواهی نمایه سازی
- من نویسنده این مقاله هستم
استخراج به نرم افزارهای پژوهشی:
شناسه ملی سند علمی:
IIWC01_058
تاریخ نمایه سازی: 6 مهر 1391
چکیده مقاله:
resistance upset welding is used for joining heating alloy 8i0Ni-20Cr. This process is performed using heat and pressure simultaneously . Acceptable weld be achieved when the resistivity differences betweenwelded and original elemetnts are less than 10 percent and appropriate tensile strength is acquired there are three main parameters in resistance upset welding electrical power applied pressure and welding time in this research effect of these parameters on structure resistivity and fracture strength of 1.6 mm wire elements has been studied results show that increase of welding power leads to change in resistivity less than 10 percent the fracture strength reaches to its maximum first and subsequently decreases due to coarsening of GAZ grains by properly choosing of welding pressure roughness of joining surfaces is lowered and decreases resistivity and its changes results are satisfying .
کلیدواژه ها:
نویسندگان
a halvaee
university of tehran
r pahlevan
rolling mill&steel production co
h moghareh
arian gostaresh etesal co
مراجع و منابع این مقاله:
لیست زیر مراجع و منابع استفاده شده در این مقاله را نمایش می دهد. این مراجع به صورت کاملا ماشینی و بر اساس هوش مصنوعی استخراج شده اند و لذا ممکن است دارای اشکالاتی باشند که به مرور زمان دقت استخراج این محتوا افزایش می یابد. مراجعی که مقالات مربوط به آنها در سیویلیکا نمایه شده و پیدا شده اند، به خود مقاله لینک شده اند :