Manufacture of low melting point alloys forming dies for sheet metals
سال انتشار: 1384
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 1,595
فایل این مقاله در 8 صفحه با فرمت PDF قابل دریافت می باشد
- صدور گواهی نمایه سازی
- من نویسنده این مقاله هستم
استخراج به نرم افزارهای پژوهشی:
شناسه ملی سند علمی:
ICME07_151
تاریخ نمایه سازی: 6 آذر 1388
چکیده مقاله:
This paper is the outcome of a research on the application of low melting point alloys for the manufacture of forming dies. Using low melting point alloy MCP137, the punch and matrix for a forming die were manufactured. The alloy was moulded using the casting process using a model to make the die. Using FEM ABAQUS software the die was modelled and analyzed to obtain the stress distribution in the male and female dies. The casting process was also simulated using Magmasoft software. Using these die aluminium sheet metals was formed. Comparison of simulation and experimental data showed good agreements.
کلیدواژه ها:
نویسندگان
K Abrinia
Assistant Professor, Mechanical Engineering Department, Faculty of Technology, University of Tehran
A Darwish
Associate Professor, Mechanical Engineering Department, University of Mazandaran
M Mohammadi
Postgraduate Student, Mechanical Engineering Department, Faculty of Technology, University of Tehran
مراجع و منابع این مقاله:
لیست زیر مراجع و منابع استفاده شده در این مقاله را نمایش می دهد. این مراجع به صورت کاملا ماشینی و بر اساس هوش مصنوعی استخراج شده اند و لذا ممکن است دارای اشکالاتی باشند که به مرور زمان دقت استخراج این محتوا افزایش می یابد. مراجعی که مقالات مربوط به آنها در سیویلیکا نمایه شده و پیدا شده اند، به خود مقاله لینک شده اند :