Experimental investigation of hard spline milling using a newly developed disk cutter
محل انتشار: مجله مکانیک کاربردی محاسباتی، دوره: 53، شماره: 1
سال انتشار: 1401
نوع سند: مقاله ژورنالی
زبان: انگلیسی
مشاهده: 196
فایل این مقاله در 10 صفحه با فرمت PDF قابل دریافت می باشد
- صدور گواهی نمایه سازی
- من نویسنده این مقاله هستم
استخراج به نرم افزارهای پژوهشی:
شناسه ملی سند علمی:
JR_JCAM-53-1_008
تاریخ نمایه سازی: 11 اردیبهشت 1401
چکیده مقاله:
Machining hardened steels is a common requirement in various industries. This includes gearing and spline cutting on hardened steel parts at high speeds. Traditionally, gearing tools were made of high-speed steels, which made them suitable only for gearing at low cutting speeds with coolant. However, hard gearing using disk cutters with interchangeable carbide inserts is a new and flexible method for machining various types of splines and gears without special equipment. In this research, a disk cutter with four carbide cutting inserts is designed and manufactured. Experimental analysis is performed to assess the applicability of the developed cutter in machining splines on hardened steel axle shafts. Workpieces made of DIN ۶۰SiMn۵ steel with a hardness of ۴۶ HRC and AISI ۱۵۵۲ steel with a hardness of ۶۱ HRC are machined using two types of carbide inserts in wet and dry cutting conditions. Results show achieved surface roughness values in the range of ۰.۱۶۱ μm < Ra < ۰.۳۷۶ μm, which is an indication of a very good surface quality. Also, ANOVA methods are used to assess the impact of input parameters on machined surface roughness and cutting tool wear. The analysis shows that surface roughness is most affected by insert type, while use of coolant is the most effective parameter on tool wear. This research also proves applicability of dry milling as a sustainable and environmentally friendly method for spline cutting on hardened steels.
کلیدواژه ها:
نویسندگان
Ali Reza Khiabani
Department of Mechanical Engineering, Faculty of Engineering, Ferdowsi University of Mashhad, Mashhad, Iran
Amir Mohammad Ghandehariun
Department of Mechanical Engineering, Faculty of Engineering, Ferdowsi University of Mashhad, Mashhad, Iran
مراجع و منابع این مقاله:
لیست زیر مراجع و منابع استفاده شده در این مقاله را نمایش می دهد. این مراجع به صورت کاملا ماشینی و بر اساس هوش مصنوعی استخراج شده اند و لذا ممکن است دارای اشکالاتی باشند که به مرور زمان دقت استخراج این محتوا افزایش می یابد. مراجعی که مقالات مربوط به آنها در سیویلیکا نمایه شده و پیدا شده اند، به خود مقاله لینک شده اند :