Vector Control Methods for Star-Connected Three-Phase Induction Motor ‎Drives Under the Open-Phase Failure

Reliability for electric motor drive systems is very vital in some industries. Selecting an appropriate control strategy for driving an electric motor during fault conditions is one of the most important issues mainly for safety-critical applications. Recently, vector control (VC) strategies have been extensively developed for star-connected three-phase induction motor drives during single-phase cut-off fault (COF) based on two different transformation matrices (TMs). Despite the effectiveness of these methods during the fault, these control systems are very complex due to their extensive on-line computation. This paper presents two simple methods based on indirect VC (IVC) and direct VC (DVC) methods for controlling a star-connected three-phase induction motor during the fault condition. The fault in this paper is limited to single-phase COF which can occur in motor stator coils. In this paper, it is shown that using a suitable TM and some changes in the control parameters, it is possible to control the faulted drive system. Performance of the proposed control methods is verified using MATLAB software and DSP/TMS۳۲۰F۲۸۳۳۵ controller board for a ۰.۷۵kW star-connected three-phase induction motor drive system. The achieved results show the good performance of the introduced control systems in different operating conditions. In addition, the results demonstrate the performance of the proposed VC strategies and that of the previous works are almost the same. However, the proposed VC methods in this paper need less modification in the structure of the standard VC strategy than the previous works.

کلیدواژه ها:

control of the faulted drive system ، direct and indirect vector controllers ، Induction Motor ، single-phase cut-off fault ، transformation matrix