Fabrication modified electrochemical sensor to detect and measure phenols in oily waste water
محل انتشار: اولین سمپوزیوم بین المللی نانو تکنولوژی
سال انتشار: 1395
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 579
نسخه کامل این مقاله ارائه نشده است و در دسترس نمی باشد
- صدور گواهی نمایه سازی
- من نویسنده این مقاله هستم
استخراج به نرم افزارهای پژوهشی:
شناسه ملی سند علمی:
ISON01_003
تاریخ نمایه سازی: 26 شهریور 1395
چکیده مقاله:
In this research work, a layer involving gold nano particle, poly pyrole and syntheic ligand modified were electro deposited on the surface of gold bare electrode using cyclic voltametry technique. In this way, a modified electrode is made at room temperature for determination of phenol at pH= 9 fixed by Briton Robinson (B-R) buffer solution under the optimized chemical and instrumental parameters. The cyclic voltametry (CV), Square wave (SqW) and techniques were used to electrochemical study of modified electrode. The scanning electron microscopy (SEM) technique was used to morphological study of the electrode surface. This modified electrode responds to phenol over the concentration range of 0.5 to 100 nM. Other advantages of this modified electrode are high signal to noise ratio, wide dynamic range of response, high sensitivity and also responsibility toward phenol in its real samples without any side serious interferences.
کلیدواژه ها:
نویسندگان
Zaynab Mahdian Rad
Chemical Engineering Group, Faculty of Engineering, Islamic Azad University of Kermanshah Branch, Kermanshah, Iran. Chemical Engineering Group, Faculty of Sciences, Science and Research Branch Islamic Azad University of Kermanshah Branch, Kermanshah, Iran
Aeash Babakhanian
Chemical Engineering Group, Faculty of Engineering, Islamic Azad University of Kermanshah Branch, Kermanshah, Iran